README web version of /home/usg/OPS/MTS/readme_xml/readme_83080500

Principal Investigator Email Address

```
wkerzendorf@gmail.com
```

Estimated Total Execution Time (hours, including overheads)

```
13 h
```

General Description

The Observations are aimed at trying to get spectra of all stars in a
 113 arcsecond field around SN1006 to a I mag of 18 with a minimum S/N of 12 and
 a S/N of more than 15 with candidates brighter than 17.5. The observations are split
 up in 3 Fibre configurations. One of the configurations has a maximum magnitude
 of 17, thus requiring less exposure time to reach the required minimum S/N ratio
 (I allocated 3 OBs with 45 min exposure time each). The other two configuration
 have fainter stars and thus I allocated 5 OBs (with 45 min exposure time each) to
 reach the required minimum S/N. 
The observation itself does not require any special calibration.
The information we are trying to extract is radial velocity (+- 2 km/s), rotational
 velocity and chemical composition.

Waiver Requests

```
No Waiver Request was submitted
```

Critical Observing Condition Constraints

```
Specified in the OBs
```

Time-Critical Aspects

when target has airmass of less than 1.5

Special Execution Requirements

---(Empty)---

Special Calibration Information

---(Empty)---

ToO Information

---(Empty)---

ToO Activators List

---(Empty)---

Do all your OBs comply with the instrument-specific requirements listed on the instrument-specific Phase 2 web page ?

Do all your finding charts comply with both the general and instrument-specific Phase 2 Web Pages ?

If you submitted OBs for standard stars, did you specify the magnitude and spectral type of all standard stars in the OBs ?

```
N/A
```

Have you included OBs for any calibrations that you need but which are not part of the Calibration Plan ?

```
N/A
```

If you are observing Moving Targets, have you attached suitable ephemeris files to your OBs?

```
N/A
```

If you have preferences which OBs should be executed first, did you make use of the User Priority field in the OBs ?

```
N/A
```

If this is a run that requires coordinated observations with other facilities, did you give proper instructions in the Time-Critical Aspects Section ?

```
N/A
```

Did you specify in your OBs the hour angle range for which your Target Setup files are valid ?

Did you specify in your OBs the magnitudes of FACBs and Guide Star for all your fields ?

Are the FACBs and Guide Star in the brightness ranges specified in the FLAMES manual ?

Did you enter the expected signal to noise in your OBs ?

Last creation of page: Tue Oct 6 15:40:30 2009
If you have comments, please contact usd-help@eso.org