README web version of /home/usg/OPS/MTS/readme_xml/readme_83045101
Principal Investigator Email Address
Estimated Total Execution Time (hours, including overheads)
General Description
Description: FastJitter observations of TNO stellar occultations.
Each observation is activated by a ToO trigger because, at OB submission time, we
do not know the occultation time with
sufficient accuracy. NB: it is a time critical program and, once activated, the
OB should start at the UT time specified in the
trigger
The observation are performed either in J or Ks filter (depending target SED), and
either thru a
squared or a rectangular window. The rectangular window will allow to observe a
reference star, if any, for relative
photometry.
The trigger will specify the required filter/OB, DIT, NDIT, Position Angle &
windowing parameters
Finding charts will clearly mark the target and the reference star. we will draw
the windowed detector FoV to
facilitate acquisition. Please make sure that both target & reference star are
in FoV
Waiver Requests
Critical Observing Condition Constraints
Time-Critical Aspects
Special Execution Requirements
Special Calibration Information
We submit the following calibration OBs:
- dark sequence, to be observed with the same windowing pameters as the science
data
- dome flat J and Ks OBs, to be observed with the same windowing parameters as the
science data;
ToO Information
ToO Activators List
Is this a Pre-imaging run ?
Pre-imaging Requirements
Source(s) of Pre-imaging
Pre-imaging sources not listed above
Do all your OBs comply with the instrument-specific requirements listed
on the instrument-specific Phase 2 web page ?
If this is a pre-imaging run, did you select PRE-IMAGING for the Observing
Category for each Observing Template ?
Do all your finding charts comply with both the general and instrument-specific
Phase 2 Web Pages ?
If you submitted OBs for standard stars, did you specify the magnitude
and spectral type of all standard stars in the OBs ?
Have you included OBs for any calibrations that you need but which are
not part of the Calibration Plan ?
If you are observing Moving Targets, have you attached suitable ephemeris
files to your OBs?
If you have preferences which OBs should be executed first, did you make
use of the User Priority field in the OBs ?
If this is a run that requires coordinated observations with other facilities,
did you give proper instructions in the Time-Critical Aspects Section ?
Last creation of page: Tue Oct 6 15:40:29 2009
If you have comments, please contact usd-help@eso.org