README web version of /home/usg/OPS/MTS/readme_xml/readme_82016301
Principal Investigator Email Address
Estimated Total Execution Time (hours, including overheads)
General Description
This is a plain imaging run targetting the lensing cluster A2667.
The present run (B) is the near-IR part of the survey (filters YJHK),
whereas run (A) with FORS2 corresponds to the optical (Iz). Target pointing
is optimized in order to maximize the common area between FORS2 and Hawk-I,
taking into account the observation constraints introduced by Hawk-I topology.
In particular, the center of the cluster is shifted with respect to the center
of Hawk-I.
The center of Hawk-I is indicated by a red cross on the finding chart.
A single finding chart is provided for all OBs: centering position for each OB
is only a relatively small shift (about the size of the red cross) compared to
HAWKI field. This single finding chart should then be sufficient to check
telescope pointing.
The image used for the finding chart comes from the UH 2.2m telescope (R-band).
There are very few "bright" stars in this field, except for a star of
magnitudes (from 2mass, Vega system): J=10.3, H=10.069, K=9.983.
Waiver Requests
Critical Observing Condition Constraints
Time-Critical Aspects
Special Execution Requirements
Special Calibration Information
ToO Information
ToO Activators List
Is this a Pre-imaging run ?
Pre-imaging Requirements
Source(s) of Pre-imaging
Pre-imaging sources not listed above
Do all your OBs comply with the instrument-specific requirements listed
on the instrument-specific Phase 2 web page ?
If this is a pre-imaging run, did you select PRE-IMAGING for the Observing
Category for each Observing Template ?
Do all your finding charts comply with both the general and instrument-specific
Phase 2 Web Pages ?
If you submitted OBs for standard stars, did you specify the magnitude
and spectral type of all standard stars in the OBs ?
Have you included OBs for any calibrations that you need but which are
not part of the Calibration Plan ?
If you are observing Moving Targets, have you attached suitable ephemeris
files to your OBs?
If you have preferences which OBs should be executed first, did you make
use of the User Priority field in the OBs ?
If this is a run that requires coordinated observations with other facilities,
did you give proper instructions in the Time-Critical Aspects Section ?
If you submitted OBs for standard stars, did you use the provided StandardStar
templates ?
If you are using a specific offset pattern or position angle, did you
check carefully the definition in the manual ?
Did you enter the magnitude of the brightest star in the field-of-view
in the 'Instrument Comments' field of each OB ?
If you use the MoveToPixel acquisition, have you given clear instructions
on the FC and in the OB comment section as to how the field should be centered ?
Last creation of page: Tue Oct 6 15:40:26 2009
If you have comments, please contact usd-help@eso.org