README web version of /home/usg/OPS/MTS/readme_xml/readme_81025500

Principal Investigator Email Address

```
asollima@iac.es
```

Estimated Total Execution Time (hours, including overheads)

```
18
```

General Description

This observing program is devoted to the study of the velocity dspersion
 profile of the giant stellar system omega Centauri (NGC5139).
It consists in a set of 32 1200s-long FLAMES pointings in a region between 0.25
 and 1.2 deg from the cluster center. 
The expected S/N ratio is >20 for all the targets. 
There are no special requirements for lunar phase and seeing conditions.
Magnitudes in the .ins files are in the K band (from 2MASS), the R magnitudes of
 the VLT guide star and of the FACB stars have been specified in the Instrument comment
 section for each OB.

Waiver Requests

```
No Waiver Request was submitted
```

Critical Observing Condition Constraints

```
None
```

Time-Critical Aspects

```
None
```

Special Execution Requirements

```
None
```

Special Calibration Information

```
None
```

ToO Information

```
None
```

ToO Activators List

```
None
```

Is this a Pre-imaging run ?

```
false
```

Pre-imaging Requirements

```
None
```

Source(s) of Pre-imaging

---(Empty)---

Pre-imaging sources not listed above

---(Empty)---

Do all your OBs comply with the instrument-specific requirements listed on the instrument-specific Phase 2 web page ?

If this is a pre-imaging run, did you select PRE-IMAGING for the Observing Category for each Observing Template ?

Do all your finding charts comply with both the general and instrument-specific Phase 2 Web Pages ?

If you submitted OBs for standard stars, did you specify the magnitude and spectral type of all standard stars in the OBs ?

Have you included OBs for any calibrations that you need but which are not part of the Calibration Plan ?

If you are observing Moving Targets, have you attached suitable ephemeris files to your OBs?

If you have preferences which OBs should be executed first, did you make use of the User Priority field in the OBs ?

If this is a run that requires coordinated observations with other facilities, did you give proper instructions in the Time-Critical Aspects Section ?

Did you specify in your OBs the hour angle range for which your Target Setup files are valid ?

Did you specify in your OBs the magnitudes of FACBs and Guide Star for all your fields ?

Are the FACBs and Guide Star in the brightness ranges specified in the FLAMES manual ?

Did you enter the expected signal to noise in your OBs ?

Last creation of page: Tue Oct 6 15:40:23 2009
If you have comments, please contact usd-help@eso.org