README web version of /home/usg/OPS/MTS/readme_xml/readme_80047702
Principal Investigator Email Address
Estimated Total Execution Time (hours, including overheads)
General Description
The purpose of this ToO proposal is to take long-slit spectra of three
previously-confirmed high-redshift Type Ia supernovae at two phases in their evolution
(seperated by ~2 observer-frame weeks). We require a unique setup for these observations:
LSS mode, 1.0" slit, 300V grism, GG435 filter. The targets are given the preliminary
name "SN2007xx" as these supernovae are yet to be discovered. We have prepared one
OB per exposure time request (see ToO information) to cover faint/bright targets.
We will provide the RA, DEC, finding chart, and target name at trigger. We may
also require that the position angle be set to a different value than its default
(0), to include another target, e.g. the host galaxy of the supernova, in the same
spectroscopic
slit.
Waiver Requests
Critical Observing Condition Constraints
Time-Critical Aspects
Special Execution Requirements
Special Calibration Information
We have provided OBs for flux-calibration of our spectra. The OBs are
called: ToO_CAL__LSS, where is the name of the
standard star: STD_NAME Vmag SpecType -------------------------------- Feige110 11.83 DOp
LTT2415 12.21 F? LTT9491 14.10 DC VanMaanen2 12.38 DZ7 We have set the exposure
time to 60s in each case (00:13:57.000 execution time in each case), but we ask
the service observer to adjust the exposure times slightly to ensure there are sufficient
counts while avoiding saturation. We will usually request one such calibration
spectrum one the same
night as the science observation.
ToO Information
This is a ToO run. The supernovae we are planning to follow-up spectroscopically
are yet to be discovered. The supernova coordinates, magnitude, phase will be provided
by members of the ESSENCE Team, who will have a first spectrum to confirm the supernova
is indeed of type Ia. We do not yet know the magnitudes of these targets, which
depend both on the individual supernova and its phase. However, we expect these
to be in the range R = 22.0-23.5. We have prepared a set of OBs, all identical except
for the exposure times. Some comprise two exposures, others three, with a 6" offset
between each. Below are the integration times and the corresponding total execution
time (as reported by p2pp) of each OB: Exposure Time Execution Time ------------------------------
3 x 1200s 01:18:48.000 3 x 1500s 01:33:48.000 3 x 1800s 01:48:48.000
The OB names reflect these exposure times, and are called: ToO_SN2007xx_LSS_exp, ToO_SN2007xx_LSS_exp3x1200, is an OB consisting of 3 exposures of 1200s
(20 minutes) each, with
offsets of 6" between each 1200s exposure.
ToO Activators List
Is this a Pre-imaging run ?
Pre-imaging Requirements
Source(s) of Pre-imaging
Pre-imaging sources not listed above
Do all your OBs comply with the instrument-specific requirements listed
on the instrument-specific Phase 2 web page ?
If this is a pre-imaging run, did you select PRE-IMAGING for the Observing
Category for each Observing Template ?
Do all your finding charts comply with both the general and instrument-specific
Phase 2 Web Pages ?
If you submitted OBs for standard stars, did you specify the magnitude
and spectral type of all standard stars in the OBs ?
Have you included OBs for any calibrations that you need but which are
not part of the Calibration Plan ?
If you are observing Moving Targets, have you attached suitable ephemeris
files to your OBs?
If you have preferences which OBs should be executed first, did you make
use of the User Priority field in the OBs ?
If this is a run that requires coordinated observations with other facilities,
did you give proper instructions in the Time-Critical Aspects Section ?
If you have prepared your finding charts with tools other than FIMS,
do they comply with the specifications on the FORS1 Phase 2 web page ?
Last creation of page: Tue Oct 6 15:40:21 2009
If you have comments, please contact usd-help@eso.org