README web version of /home/usg/OPS/MTS/readme_xml/readme_79034211
Principal Investigator Email Address
Estimated Total Execution Time (hours, including overheads)
General Description
We are searching for the absorption signatures of gas clouds produced
by
sublimating comets grazing the white dwarf GD56. We focus on the Ca II doublet stellar
lines around 393 nm and 397 nm, and try to evidence extra absorptions around those
two lines. These absorptions should be both variable in wavelength/radial velocity
and intensity in the vicinity of the stellar lines. We expect the cometary absorptions
to be around 10% of the stellar line intensity. We aim at obtaining a S/N of 30-50
with a resolution of 3 km/s, in order to have a 10-sigma detection.
Waiver Requests
(Waiver request on the 7/2/7, granted on the 8/2/7)
I would like to program five separated blocks of 2.2h continuous observations. I
would need to set five 2.2h-long OBs (runs K to O), with each of them exceeding
the 1h limit. The reason why I need contiguous observations is that I am looking
for a spectroscopic transient absorption, which timescale is of a few hours. In
case I split one run in 2 or 3 non-contiguous OBs (for instance, one 1h-OB taken
one night and another 1h-OB another night), the event could be seen in one OB and
not in the others, resulting in a non- or bad detection. I therefore ask for waivers
for runs K to O, allowing to set five 2.2h-long OBs.
Critical Observing Condition Constraints
Time-Critical Aspects
We need that each OB (or each Run in our case) be scheduled some nights
apart (i.e., no more than one OB per night). However, they can be randomly scheduled
and do NOT need to be programmed over contiguous nights.
Special Execution Requirements
Special Calibration Information
ToO Information
ToO Activators List
Is this a Pre-imaging run ?
Pre-imaging Requirements
Source(s) of Pre-imaging
Pre-imaging sources not listed above
Do all your OBs comply with the instrument-specific requirements listed
on the instrument-specific Phase 2 web page ?
If this is a pre-imaging run, did you select PRE-IMAGING for the Observing
Category for each Observing Template ?
Do all your finding charts comply with both the general and instrument-specific
Phase 2 Web Pages ?
If you submitted OBs for standard stars, did you specify the magnitude
and spectral type of all standard stars in the OBs ?
Have you included OBs for any calibrations that you need but which are
not part of the Calibration Plan ?
If you are observing Moving Targets, have you attached suitable ephemeris
files to your OBs?
If you have preferences which OBs should be executed first, did you make
use of the User Priority field in the OBs ?
If this is a run that requires coordinated observations with other facilities,
did you give proper instructions in the Time-Critical Aspects Section ?
If you need secondary guiding, are there suitable objects within 30 arcsec
from your target ?
Last creation of page: Tue Oct 6 15:40:19 2009
If you have comments, please contact usd-help@eso.org