README web version of /home/usg/OPS/MTS/readme_xml/readme_78082502
Principal Investigator Email Address
Estimated Total Execution Time (hours, including overheads)
General Description
With this observational run we plan to obtain 6 radial velocities points
for each of the 87 EHB target stars in the globular cluster NGC2808.
In this way we want to search binary stars among these EHB and to measure
their fraction, period, and spatial distribution.
If present, these binaries could be a channel of production of EHB stars.
Waiver Requests
Critical Observing Condition Constraints
Our targets are relatively faint stars. For this reason
we need a clear sky, a seeing of 0.8 arcsec, and an airmass less than
1.6 to reach the expected S/N.
The moon should be at least at 30 degrees from our target.
But for us the temporal sempling is very important so we can accept
a seeing of 1.0'' and no moon constrains if this help our OBs to be observed
as specified in "Time-Critical Aspects" and "Special Execution Requirements" sections.
Time-Critical Aspects
This service mode observing run (078.D-0825(C)) is a third
epoch observation and should be taken after about 80 days
from the first epoch observation.
The fist epoch observation is the visitor mode 078.D-0825(A)
program and will begin the 10th of Jenuary 2007, so you must consider
this date as first epoch.
We can accept a seeing of 1.0'' and no moon constrains if this help
our OBs to be observed 80 days after the first epoch.
Special Execution Requirements
Special Calibration Information
ToO Information
ToO Activators List
Is this a Pre-imaging run ?
Pre-imaging Requirements
Source(s) of Pre-imaging
Pre-imaging sources not listed above
Do all your OBs comply with the instrument-specific requirements listed
on the instrument-specific Phase 2 web page ?
If this is a pre-imaging run, did you select PRE-IMAGING for the Observing
Category for each Observing Template ?
Do all your finding charts comply with both the general and instrument-specific
Phase 2 Web Pages ?
If you submitted OBs for standard stars, did you specify the magnitude
and spectral type of all standard stars in the OBs ?
Have you included OBs for any calibrations that you need but which are
not part of the Calibration Plan ?
If you are observing Moving Targets, have you attached suitable ephemeris
files to your OBs?
If you have preferences which OBs should be executed first, did you make
use of the User Priority field in the OBs ?
If this is a run that requires coordinated observations with other facilities,
did you give proper instructions in the Time-Critical Aspects Section ?
Did you specify in your OBs the hour angle range for which your Target
Setup files are valid ?
Did you specify in your OBs the magnitudes of FACBs and Guide Star for
all your fields ?
Are the FACBs and Guide Star in the brightness ranges specified in the
FLAMES manual ?
Did you enter the expected signal to noise in your OBs ?
Last creation of page: Tue Oct 6 15:40:17 2009
If you have comments, please contact usd-help@eso.org