README web version of /home/usg/OPS/MTS/readme_xml/readme_78079103
Principal Investigator Email Address
Estimated Total Execution Time (hours, including overheads)
General Description
Dear observer
This program is aimed at obtaining spctra of different stellar populations in the
outer parts of the Small Magellanic Cloud galaxy. Our analysis will combine different
spectral settings on the same target list of objects to measure stellar parameters.
We do not need photometric conditions, however seeking for good S/N on faint objects
seeing can be important. Anyway since SMC never reach low airmasses it would be
nice if observations are alwaays performed during the meridian passage.
The target stars list have been astrometrized from a WFI image aginst the UCAC2
system. The Guide
and Fiducial stars are on the same UCAC2 system. We verified that the accuracy of
the guide/target
astrometry difference is better than 0.2 arcsec rms. No offsets should be present.
Waiver Requests
Critical Observing Condition Constraints
We do NOT need the night to be photometric.
It is enough that it is CLEAR.
Given the coordinates of our target field, we relaxed our seeing observing
constraint to 1.8 arcsec, and the airmass up to 2.0
Time-Critical Aspects
Special Execution Requirements
Special Calibration Information
ToO Information
ToO Activators List
Is this a Pre-imaging run ?
Pre-imaging Requirements
Source(s) of Pre-imaging
Pre-imaging sources not listed above
Do all your OBs comply with the instrument-specific requirements listed
on the instrument-specific Phase 2 web page ?
If this is a pre-imaging run, did you select PRE-IMAGING for the Observing
Category for each Observing Template ?
Do all your finding charts comply with both the general and instrument-specific
Phase 2 Web Pages ?
If you submitted OBs for standard stars, did you specify the magnitude
and spectral type of all standard stars in the OBs ?
Have you included OBs for any calibrations that you need but which are
not part of the Calibration Plan ?
If you are observing Moving Targets, have you attached suitable ephemeris
files to your OBs?
If you have preferences which OBs should be executed first, did you make
use of the User Priority field in the OBs ?
If this is a run that requires coordinated observations with other facilities,
did you give proper instructions in the Time-Critical Aspects Section ?
Did you specify in your OBs the hour angle range for which your Target
Setup files are valid ?
Did you specify in your OBs the magnitudes of FACBs and Guide Star for
all your fields ?
Are the FACBs and Guide Star in the brightness ranges specified in the
FLAMES manual ?
Did you enter the expected signal to noise in your OBs ?
Last creation of page: Tue Oct 6 15:40:17 2009
If you have comments, please contact usd-help@eso.org