README web version of /home/usg/OPS/MTS/readme_xml/readme_78078701
Principal Investigator Email Address
Estimated Total Execution Time (hours, including overheads)
General Description
Target is a FAINT (K~20), BIG (~2.5") high z galaxy, which we observe
at 4 different positions in the 8x8" FOV (--> hence no need for sky positions).
The offset star (H=16.9) must be ACCURATELY CENTERED in the fov because the galaxies
are so big (subtract sky frame first if necessary). Continuum might be visible after
subtracting two frames and median collapsing, but do NOT worry if no continuum is
seen.
The observing sequence starts with observing the offset star at the first two positions
(AB) where the target will be observed, then observing the target at 4 different
positions (ABCD) and then observing the offset star again at the last two positions
(CD). Rationale is that based on extensive visitor mode experience we have noticed
that the target can move significantly on the chip (depending on parallactic angle,
elevation etc). We correct for this using the star observations during the data
reduction.
Two finding charts have been attached. The first ("fc_big_UDF2.jpg") shows a large
area with the target and offset star. The second ("fc_small_UDF2.jpg") shows the
8x8 arcsecond fov at the different offset positions on the science target (red-magenta-blue-green
squares).
Note the large distance between offset star and target: 63".
"Verify" gives a warning that the target moves outside the FOV. IGNORE this warning
(the target is in the FOV, it the OB structure (first observing a psf star &
not using the blind offset option) that causes this error.
Waiver Requests
We have submitted a waiver request on Fri, 07 Jul 2006, which was approved
on 14 Jul 2006, requesting
1) have more than once Science template
2) take up to 1.5 hours to execute.
Critical Observing Condition Constraints
Time-Critical Aspects
Special Execution Requirements
Special Calibration Information
ToO Information
ToO Activators List
Is this a Pre-imaging run ?
Pre-imaging Requirements
Source(s) of Pre-imaging
Pre-imaging sources not listed above
Do all your OBs comply with the instrument-specific requirements listed
on the instrument-specific Phase 2 web page ?
If this is a pre-imaging run, did you select PRE-IMAGING for the Observing
Category for each Observing Template ?
Do all your finding charts comply with both the general and instrument-specific
Phase 2 Web Pages ?
If you submitted OBs for standard stars, did you specify the magnitude
and spectral type of all standard stars in the OBs ?
Have you included OBs for any calibrations that you need but which are
not part of the Calibration Plan ?
If you are observing Moving Targets, have you attached suitable ephemeris
files to your OBs?
If you have preferences which OBs should be executed first, did you make
use of the User Priority field in the OBs ?
If this is a run that requires coordinated observations with other facilities,
did you give proper instructions in the Time-Critical Aspects Section ?
Did you indicate the magnitude of the brightest object in the field in
each SINFONI OB?
If you are using the AO: Did you indicate for every OB the magnitude
of the guide star, and its distance to the target (if any)?
If you submitted OBs for standard stars, did you use the provided StandardStar
templates?
If you are using a specific offset pattern or position angle: did you
check carefully the definition in the manual?
Did you make really sure that none of your OBs ever saturates the detector?
If you are using the AO: did you enter the correct Strehl Ratio (on-axis,
K-band) AND the seeing value in the constraint set?
Last creation of page: Tue Oct 6 15:40:17 2009
If you have comments, please contact usd-help@eso.org