README web version of /home/usg/OPS/MTS/readme_xml/readme_78010900
Principal Investigator Email Address
Estimated Total Execution Time (hours, including overheads)
General Description
This program is aimed at obtaining high S/N spectra covering the CIV 1549
and the CIII] 1909 blend in high redshift (z around 3) quasars. The lines, redshifted
into the r band, are covered by a single spectral frame for each object up to ~
8500 Angstroms.
Targets are relatively bright quasars (r < 19) and should not require a blind
offset. A check with the ETC for FORS1 indicate a very high S/N is reached for r=19
through filter GG435+31 in 20 sec acquisition exposures.
Parallactic position angle (9999 code in acquisition template) is preferred; otherwise
PA=0 is OK.
Waiver Requests
Waiver Request 078.B-0.109A.01.WAV was approved on Oct. 31.
It requests OBs in excess of 1h for targets
J23509-0052, J00103-0037, J00521-1108,J01390-0824, J01583-0012, J02390-0038
Critical Observing Condition Constraints
Time-Critical Aspects
Special Execution Requirements
Special Calibration Information
ToO Information
ToO Activators List
Is this a Pre-imaging run ?
Pre-imaging Requirements
Source(s) of Pre-imaging
Pre-imaging sources not listed above
Do all your OBs comply with the instrument-specific requirements listed
on the instrument-specific Phase 2 web page ?
If this is a pre-imaging run, did you select PRE-IMAGING for the Observing
Category for each Observing Template ?
Do all your finding charts comply with both the general and instrument-specific
Phase 2 Web Pages ?
If you submitted OBs for standard stars, did you specify the magnitude
and spectral type of all standard stars in the OBs ?
Have you included OBs for any calibrations that you need but which are
not part of the Calibration Plan ?
If you are observing Moving Targets, have you attached suitable ephemeris
files to your OBs?
If you have preferences which OBs should be executed first, did you make
use of the User Priority field in the OBs ?
If this is a run that requires coordinated observations with other facilities,
did you give proper instructions in the Time-Critical Aspects Section ?
If you have prepared your finding charts with tools other than FIMS,
do they comply with the specifications on the FORS1 Phase 2 web page ?
Last creation of page: Tue Oct 6 15:40:15 2009
If you have comments, please contact usd-help@eso.org