README web version of /home/usg/OPS/MTS/readme_xml/readme_76052501
Principal Investigator Email Address
Estimated Total Execution Time (hours, including overheads)
General Description
Our goal is to obtain 3 radial-velocity measurements for about 1600 main-sequence
stars in the open cluster NGC 2447 with GIRAFFE-MEDUSA. From these measurements,
we will be able to establish cluster memberships of the targets. Morevover, binary
stars will be uncovered.
We have prepared 13 plate configurations. Each plate configuration has to be observed
3 times. The first epoch will be taken in December 2005, the second between December
2005 and March 2006 and the third epoch in March 2006. The timing of the observations
is not critical. There are only 2 easy constraints:
1) the same field should not be observed twice during the same night
2) we want to maximize the time span between the first and the tird epoch. This
is why observing months have been specified (December 2005 and March 2006). The
date of the second epoch is not important if constraint number 1 is respected.
About OB names:
NGC2447_field_01_A corresponds to epoch 1 of the first field (taken during run A)
NGC2447_field_01_B is the second epoch of the same field (taken during run B)
NGC2447_field_01_C is the third epoch of the same field (taken during run C)
NGC2447_field_02_A is the first epoch of the second field (taken during run A)
etc...
The "B" OB of a field should not be taken before the "A" and the "C" not before
the "A" or the "B". "B" OB of a field can be taken even if there are still missing
"A" for other fields.
Waiver Requests
Critical Observing Condition Constraints
Time-Critical Aspects
Special Execution Requirements
Special Calibration Information
ToO Information
ToO Activators List
Is this a Pre-imaging run ?
Pre-imaging Requirements
Source(s) of Pre-imaging
Pre-imaging sources not listed above
Do all your OBs comply with the instrument-specific requirements listed
on the instrument-specific Phase 2 web page ?
If this is a pre-imaging run, did you select PRE-IMAGING for the Observing
Category for each Observing Template ?
Do all your finding charts comply with both the general and instrument-specific
Phase 2 Web Pages ?
If you submitted OBs for standard stars, did you specify the magnitude
and spectral type of all standard stars in the OBs ?
Have you included OBs for any calibrations that you need but which are
not part of the Calibration Plan ?
If you are observing Moving Targets, have you attached suitable ephemeris
files to your OBs?
If you have preferences which OBs should be executed first, did you make
use of the User Priority field in the OBs ?
If this is a run that requires coordinated observations with other facilities,
did you give proper instructions in the Time-Critical Aspects Section ?
Did you specify in your OBs the hour angle range for which your Target
Setup files are valid ?
Did you specify in your OBs the magnitudes of FACBs and Guide Star for
all your fields ?
Are the FACBs and Guide Star in the brightness ranges specified in the
FLAMES manual ?
Did you enter the expected signal to noise in your OBs ?
Last creation of page: Tue Oct 6 15:40:10 2009
If you have comments, please contact usd-help@eso.org