README web version of /home/usg/OPS/MTS/readme_xml/readme_76014600

Principal Investigator Email Address

```
etolstoy@astro.rug.nl
```

Estimated Total Execution Time (hours, including overheads)

```
10:05:00
```

General Description

Three FLAMES set-ups for the same Carina target field.
2 hours HR14 (2 OBs), 3.2 hours HR13 (3 OBs), 3 hours HR10 (3 OBs). 
Please see section below, about execution priorities.

Waiver Requests

No Waiver Request was submitted. However, exposures slightly longer than
one hour were approved by USD during Phase2 review under the usual agreement,
i.e. that if conditions degrade after the 1st hour of execution, OBs will
not be repeated.

Critical Observing Condition Constraints

```
None
```

Time-Critical Aspects

```
None
```

Special Execution Requirements

Please follow priorities specified in each OB (User Priority field)
while executing this programme, i.e.

1. first complete 2 HR13 OBs (*_HR13-0, *_HR13-1)
2.  then complete 2 HR10 OBs (*_HR10-0, *_HR10-1)
3.  then complete 2 HR14 OBs (*_HR14-0, *_HR14-1)
4.  then complete last 2 OBs:  *_HR13-2 and *_HR10-2

Special Calibration Information

---(Empty)---

ToO Information

---(Empty)---

ToO Activators List

---(Empty)---

Is this a Pre-imaging run ?

```
false
```

Pre-imaging Requirements

---(Empty)---

Source(s) of Pre-imaging

---(Empty)---

Pre-imaging sources not listed above

---(Empty)---

Do all your OBs comply with the instrument-specific requirements listed on the instrument-specific Phase 2 web page ?

If this is a pre-imaging run, did you select PRE-IMAGING for the Observing Category for each Observing Template ?

```
N/A
```

Do all your finding charts comply with both the general and instrument-specific Phase 2 Web Pages ?

If you submitted OBs for standard stars, did you specify the magnitude and spectral type of all standard stars in the OBs ?

```
N/A
```

Have you included OBs for any calibrations that you need but which are not part of the Calibration Plan ?

```
N/A
```

If you are observing Moving Targets, have you attached suitable ephemeris files to your OBs?

```
N/A
```

If you have preferences which OBs should be executed first, did you make use of the User Priority field in the OBs ?

If this is a run that requires coordinated observations with other facilities, did you give proper instructions in the Time-Critical Aspects Section ?

```
N/A
```

Did you specify in your OBs the hour angle range for which your Target Setup files are valid ?

Did you specify in your OBs the magnitudes of FACBs and Guide Star for all your fields ?

Are the FACBs and Guide Star in the brightness ranges specified in the FLAMES manual ?

Did you enter the expected signal to noise in your OBs ?

Last creation of page: Tue Oct 6 15:40:09 2009
If you have comments, please contact usd-help@eso.org