README web version of /home/usg/OPS/MTS/readme_xml/readme_75086200
Principal Investigator Email Address
Estimated Total Execution Time (hours, including overheads)
General Description
This program is devoted to measure stellar abundances in the SB galaxy
NGC3256
by means of the medium resolution spectroscopy with ISAAC.
Target coordinates very accurate, taken from the 2MASS H band image of NGC3256
and refers approximately to the center of the galaxy.
If you prefer to center a star and offsetting to the galaxy, here are the coordinates
of the star on the top left corner of the FC (2MASS 10275544-4353496, J=13.2)
alpha=10h 27m 55.5s delta=-43d 53m 49.7s
and of the stars about 30 arcsec south of the galaxy (2MASS 10275160-4354450, J=14.2)
alpha=10h 27m 51.6s delta=-43d 54m 44.8s
Slit oriented as indicated in the finding chart (P.A. = +51.75 deg), in order to
be aligned
with the major axis of the galaxy and to include the tail of the spiral arm at the
SW side.
Jitter box=5'', Nod throw 60''.
2 OBs at 1.19 micron and 1 OB at 1.60 micron.
Waiver Requests
Critical Observing Condition Constraints
Time-Critical Aspects
Special Execution Requirements
Special Calibration Information
ToO Information
ToO Activators List
Is this a Pre-imaging run ?
Pre-imaging Requirements
Source(s) of Pre-imaging
Pre-imaging sources not listed above
Do all your OBs comply with the instrument-specific requirements listed
on the instrument-specific Phase 2 web page ?
If this is a pre-imaging run, did you select PRE-IMAGING for the Observing
Category for each Observing Template ?
Do all your finding charts comply with both the general and instrument-specific
Phase 2 Web Pages ?
If you submitted OBs for standard stars, did you specify the magnitude
and spectral type of all standard stars in the OBs ?
Have you included OBs for any calibrations that you need but which are
not part of the Calibration Plan ?
If you are observing Moving Targets, have you attached suitable ephemeris
files to your OBs?
If you have preferences which OBs should be executed first, did you make
use of the User Priority field in the OBs ?
If this is a run that requires coordinated observations with other facilities,
did you give proper instructions in the Time-Critical Aspects Section ?
If you submitted OBs for standard stars, did you use the provided StandardStar
templates ?
If you are using a specific offset pattern or position angle, did you
check carefully the definition in the manual ?
If you are doing spectroscopy, did you draw the slit on the Finding Charts
?
Did you enter the magnitude of the brightest star in the field-of-view
in each OB ?
If you use the MoveToPixel acquisition, have you given clear instructions
on the FC and in the OB comment section as to how the field should be centered ?
Last creation of page: Tue Oct 6 15:40:08 2009
If you have comments, please contact usd-help@eso.org