README web version of /home/usg/OPS/MTS/readme_xml/readme_75031700
Principal Investigator Email Address
Estimated Total Execution Time (hours, including overheads)
General Description
The objective of this run is to obtain high resolution, high signal-to-noise
(>200), flux calibrated spectra of 5 stars in the near infrared (centered on
860 nm).
This requires attached flatfield calibration exposures for fringing correction,
as well as observations of spectrophotometric standard stars contiguously to the
science targets. Note that the combined execution time for each target and its corresponding
standard star is not more than one hour.
One of the targets (GJ 544B) requires four observations which will be added to obtain
the required signal-to-noise.
Four of the targets are the fainter components of binary systems which might require
special care at acquisition. Binary information is indicated on the finding charts.
In the finding charts, the target position is marked with a yellow plus sign close
to the center of the chart. Yellow crosses mark artifacts contained in some of the
2MASS J band images.
Waiver Requests
Critical Observing Condition Constraints
Time-Critical Aspects
Special Execution Requirements
Special Calibration Information
Observing blocks for spectrophotometric standard stars are included. The
names of these OBs are the same as those of the corresponding target OBs, with "CAL"
added at the beginning. A "CAL" OB has to be executed immediately following the
corresponding target OB.
Magnitude and spectral type for all user supplied spectrophotometric calibration
stars:
OB name star mag(V) spectral type
----------------------------------------------------------------------------------------
CAL GJ 544B HR 5501 5.7 B9.5V
CAL GJ 570B CD -32 9927 10.4 A0
CAL GJ 628 EG 274 11.0 DA White Dwarf
CAL GJ 667C EG 274 11.0 DA White Dwarf
CAL GJ 771B HR 7596 5.6 A0III
ToO Information
ToO Activators List
Is this a Pre-imaging run ?
Pre-imaging Requirements
Source(s) of Pre-imaging
Pre-imaging sources not listed above
Do all your OBs comply with the instrument-specific requirements listed
on the instrument-specific Phase 2 web page ?
If this is a pre-imaging run, did you select PRE-IMAGING for the Observing
Category for each Observing Template ?
Do all your finding charts comply with both the general and instrument-specific
Phase 2 Web Pages ?
If you submitted OBs for standard stars, did you specify the magnitude
and spectral type of all standard stars in the OBs ?
Have you included OBs for any calibrations that you need but which are
not part of the Calibration Plan ?
If you are observing Moving Targets, have you attached suitable ephemeris
files to your OBs?
If you have preferences which OBs should be executed first, did you make
use of the User Priority field in the OBs ?
If this is a run that requires coordinated observations with other facilities,
did you give proper instructions in the Time-Critical Aspects Section ?
If you need secondary guiding, are there suitable objects within 30 arcsec
from your target ?
Last creation of page: Tue Oct 6 15:40:07 2009
If you have comments, please contact usd-help@eso.org