README web version of /home/usg/OPS/MTS/readme_xml/readme_75017500
Principal Investigator Email Address
Estimated Total Execution Time (hours, including overheads)
General Description
-- new (July 6)
Resubmission of one OB, rejected in previous submission witouht notification to
me about its rejection and reason for rejection (or rejected because of a
misunderstanding). The new OB replace one 2 min shorter.
I require a waiver (the OB is 1h0m27s long, i.e. 27s too long).
If the OB is rejected once more, please inform me about the reason.
--- previous readme
075.A-0175(A) is a moderate-deep pre-imaging for later spectroscopy (075.A-0175(B))
of
three z=1 clusters. Two targets (XLSSC029 and RzCS052) are exposed 40 min in I and
24 min in z' and are in first priority, because spectroscopy is (hopefully) taken
this semester (075.A-0175(B)). Target XLSSC035 has lower priority and
reduced exposure time (40 min in I and 4 min in z'). The reduced z' exposure
time is because a fair fraction of z' data are present in the archive (taken in
P74)
for this target.
The question "Source of pre-imaging", listed below, is unclear, and therefore not
answered.
Waiver Requests
Critical Observing Condition Constraints
Time-Critical Aspects
Special Execution Requirements
Special Calibration Information
ToO Information
ToO Activators List
Is this a Pre-imaging run ?
Pre-imaging Requirements
Source(s) of Pre-imaging
Pre-imaging sources not listed above
Do all your OBs comply with the instrument-specific requirements listed
on the instrument-specific Phase 2 web page ?
If this is a pre-imaging run, did you select PRE-IMAGING for the Observing
Category for each Observing Template ?
Do all your finding charts comply with both the general and instrument-specific
Phase 2 Web Pages ?
If you submitted OBs for standard stars, did you specify the magnitude
and spectral type of all standard stars in the OBs ?
Have you included OBs for any calibrations that you need but which are
not part of the Calibration Plan ?
If you are observing Moving Targets, have you attached suitable ephemeris
files to your OBs?
If you have preferences which OBs should be executed first, did you make
use of the User Priority field in the OBs ?
If this is a run that requires coordinated observations with other facilities,
did you give proper instructions in the Time-Critical Aspects Section ?
If you have prepared your finding charts with tools other than FIMS,
do they comply with the specifications on the FORS2 Phase 2 web page ?
Last creation of page: Tue Oct 6 15:40:06 2009
If you have comments, please contact usd-help@eso.org