README web version of /home/usg/OPS/MTS/readme_xml/readme_75008001
Principal Investigator Email Address
Estimated Total Execution Time (hours, including overheads)
General Description
The program's goal is to obtain high resolution imaging of E+A galaxies
in B & R filters. The galaxies are relatively small in size (~15" diameter)
since the redshifts are z~=0.1. However, we are also interested in the sourrounding
regions (~60" diameter), to look for low SB (B=~25.5 mag/sq.") tidal tails or other
signs for recent mergers.
The targets should in general be located close to the center of CCD #46. For targets
without close bright stars this is achieved by a RA offset of -100" and rotator=0.0.
The exposure times for the B filter is 100s, 525s, 525s and for the R filter 30s,
130s, 130s.
The following targets have relatively bright stars in the FoV and we aim to put
the bright stars outside the FoV of CCD#46 in order to avoid bad saturation and
bleeding. This is generally achieved by a rotation of +-90 degrees around the bright
star position so that the star falls on chip #45 or in the gap between the CCDs.
List of OBs with bright star problem:
E+A_1, E+A_7, E+A_9, E+A_10
The targets are circled on the finding charts. The position of the SUSI2 FoV is
only schematically indicated when a rotation is applied.
All OBs have total execution times of 30min.
Waiver Requests
Critical Observing Condition Constraints
Time-Critical Aspects
Special Execution Requirements
Special Calibration Information
ToO Information
ToO Activators List
Is this a Pre-imaging run ?
Pre-imaging Requirements
Source(s) of Pre-imaging
Pre-imaging sources not listed above
Do all your OBs comply with the instrument-specific requirements listed
on the instrument-specific Phase 2 web page ?
If this is a pre-imaging run, did you select PRE-IMAGING for the Observing
Category for each Observing Template ?
Do all your finding charts comply with both the general and instrument-specific
Phase 2 Web Pages ?
If you submitted OBs for standard stars, did you specify the magnitude
and spectral type of all standard stars in the OBs ?
Have you included OBs for any calibrations that you need but which are
not part of the Calibration Plan ?
If you are observing Moving Targets, have you attached suitable ephemeris
files to your OBs?
If you have preferences which OBs should be executed first, did you make
use of the User Priority field in the OBs ?
If this is a run that requires coordinated observations with other facilities,
did you give proper instructions in the Time-Critical Aspects Section ?
Last creation of page: Tue Oct 6 15:40:06 2009
If you have comments, please contact usd-help@eso.org