README Template 71.1 (please do not delete the README Template Version line!) ESO Programme ID: 071.D-0302(A) Principal Investigator Name: Stairs Principal Investigator E-mail Address: Ingrid Stairs Principal Investigator Telephone Number: 001-604-822-6796 Principal Investigator Postal Address: Department of Physics and Astronomy / University of British Columbia / 6224 Agricultural Road / Vancouver, BC V6T 1Z1 / Canada Instrument: ISAAC OPC Priority Class: B OPC Approved Total Execution Time: 6.0 Estimated Total Execution Time (including overheads): 6.0 README File Submission Date: 06 March 2003 Programme Description ===================== General Overview ---------------- This is straightforward spectroscopy of a target source at six epochs. At each epoch the observing sequence consists of a single OB. All OBs are identical (except for their names). The same sequence shall be observed at each epoch. Approved Waiver Request Summary ------------------------------- none Critical Observing Condition Constraints ---------------------------------------- none. Exposure times have been estimated based on the asumption of 1" seeing. Covering the epochs requested below is crucial, and reduced S/N due to poorer conditions is more acceptable than not covering the RV curve well enough. Time Critical Aspects --------------------- The program aims at determining a radial velocity curve. Periastron, and hence the most crucial part of the curve to be covered in P71 is in early April. The first the epochs/sequences should ideally be spread at roughly equal intervals during the ISAAC period in April, separated by about 5-7 days (e.g. April 6, 12, and 18). The precise dates and separations between them are not crucial. Other sampling patterns within the ISAAC period in April are less ideal, but 3 epochs (sequences) are preferable. If only two epochs/sequences can be accomodated, the third epoch/sequence should be taken in May. Epoch/run 4, 5, and 6 should ideally be taken in May, June, and July respectively. Exact dates are not crucial. Ideally the OBs of target star and velocity standard star are taken after each other, since they have the same instrumental setup. Special Calibration Information ------------------------------- We request nighttime wavelength calibration (proposal, box 9). The aim of the program is to measure RV changes precisely. The small wavelength range covered does not contain sufficient suitable atmospheric absorption lines for wavelength calibration with sufficient accuracy. Hence, nighttime calibrations are required. This is needed for one wavelength regime only (central wavelength 2.345 mu). For the second wavelength regime standard daytime calibrations are sufficient. For flats standard calibration is sufficient. ToO Information --------------- none Pre-Imaging Requirements ------------------------ none OB Information ============== List of Science OBs with Associated Finding Charts -------------------------------------------------- Total Number of Submitted Science OBs: 6 Total Number of Submitted Finding Charts: 1 71.D-0302A.001.ps List of Calibration OBs with Associated Science OBs --------------------------------------------------- Total Number of Submitted Calibration OBs: 1 Template per OB OB Compliance Checks ==================== (Y = Yes, N = No, NA = Not Applicable) Do all your OBs comply with the instrument specific requirements listed on the instrument specific Phase 2 Web pages ? [Y] If you submitted OBs for standard stars, did you specify the magnitude and spectral type of all standard stars ? [NA] Have you included OBs for any calibrations that you need but which are not a part of the Calibration Plan? [NA] [FORS only] Do all your FORS OBs use only the allowed detector read-out modes listed on the FORS1/FORS2 Phase 2 Web pages? [NA] [FORS only] Do all your FORS MOS/LSS OBs contain the mandatory "through-slit image" template? [NA] [UVES only] Do all your UVES OBs use only the allowed templates listed on the UVES Phase 2 Web pages ? [NA] [ISAAC only] Are ALL the objects in your field-of-view fainter than the magnitude limits specified on the ISAAC Phase 2 Web page ? [Y] [ISAAC only] If you submitted OBs for standard stars, did you use the provided StandardStar templates? [NA] [FLAMES only] Did you specify the hour angle range for which your Target Setup files are valid ? [NA] [WFI only]Are your finding charts 34 arcmin x 34 arcmin? [NA] If you answered "NO" to any of these questions, please revise your OBs *before* submission.