README Template 71.1 ESO Programme ID: 71.D-0033(A) Principal Investigator Name: Lundqvist Principal Investigator E-mail Address: peter@astro.su.se Principal Investigator Telephone Number: +46-8-55378518 Principal Investigator Postal Address: Dr. Peter Lundqvist, AlbaNova Science Center (SCFAB), Stockholm Observatory, Dept. of Astronomy, SE-106 91 STOCKHOLM, SWEDEN Instrument: UVES OPC Priority Class: A OPC Approved Total Execution Time: 10hrs Estimated Total Execution Time (including overheads): 10hrs README File Submission Date: Programme Description ===================== General Overview ---------------- This is a ToO program which attempts to detect narrow emission lines at the earliest observable phases of a supernova. The observations should be taken as soon as possible after the notification (if possible within the first week after explosion). Approved Waiver Request Summary ------------------------------- N/A Critical Observing Condition Constraints ---------------------------------------- N/A Time Critical Aspects --------------------- The number of follow-ups depends on the type of supernova, and whether we detect narrow lines in the first observation, or not. All this is accounted for in the OBs and will be specified in detail when the program is triggered. The first epoch observations for a SNIa or for a supernova with an unknown type: 4 x 2270 seconds with DIC1 (390+564) The first epoch observations for a SNII: 3 x 1400 seconds with DIC1 (390+564) 3 x 1400 seconds with DIC2 (437+860) For a SNIa the follow-up observations depend on whether or not the narrow CSM lines were detected in the first epoch. If there was a narrow line detection, the first epoch observation sequence will be repeated 7 and 14 days after the first observation. If no CSM lines were detected in the first epoch, a second much deeper observation will follow as soon as possible (roughly 2 days) after the first one: 6 x 2900 seconds with DIC1 (390+564) For a SNII the first epoch observation will be followed-up 3, 7, and 14 days later with the following sequence of observations: 2 x 1100 seconds with DIC1 (390+564) 2 x 1100 seconds with DIC2 (437+860) Special Calibration Information ------------------------------- A spectrophotometric standard star should be observed with the same instrument settings as the supernova on each night the supernova is observed. The spectrophotometric standard star observations with DIC1 will also be carried out with a wide (3.0") slit to allow for absolute flux calibration for the science spectrum. In addition, a telluric standard star should be observed together with the deep (6 x 2900 sec) SNIa spectrum. We will select suitable spectrophotometric and telluric standards, and provide the details together with the finding chart when triggering the ToO observations for a given supernova. ToO Information --------------- This is a ToO program. It should be activated by a supernova which will be brighter than m=16. The PI (Lundqvist), or CoI's Leibundgut, Mattila and Sollerman, will contact the observatory when such an object has been discovered and will provide the exact coordinates. A findingchart will be provided, if available, but the offsets from the galaxy nucleus plus the brightness of the object should make the acquisition unambiguous. Pre-Imaging Requirements ------------------------ OB Information ============== List of Science OBs with Associated Finding Charts -------------------------------------------------- Total Number of Submitted Science OBs: 23 Total Number of Submitted Finding Charts: - NOTE: the total time of the submitted OBs exceeds the allocation by the OPC. However, we will only make use of subsets of the OBs, i.e. either follow the SNII or the SNIa branch. Each branch individually complies with the time limit given to us. The constraints for these observations are not very strict. Therefore, some of the OBs are longer than 1.0 hour. The SNII follow-up OBs are identical. They have been duplicated to make the epochs clear. All the SNIa OBs are not identical, but depend on the results from the first observation. A finding chart will be supplied with the trigger of the program. List of Calibration OBs with Associated Science OBs --------------------------------------------------- Total Number of Submitted Calibration OBs: 13 All the DIC1 and DIC2 OBs are not identical. Observations with a wide slit (3.0") have been included in some of the DIC1 OBs to allow for absolute flux calibration of the observations. OB Compliance Checks ==================== (Y = Yes, N = No, NA = Not Applicable) Do all your OBs comply with the instrument specific requirements listed on the instrument specific Phase 2 Web pages ? [Y] If you submitted OBs for standard stars, did you specify the magnitude and spectral type of all standard stars ? [NA] Have you included OBs for any calibrations that you need but which are not a part of the Calibration Plan? [Y] [FORS only] Do all your FORS OBs use only the allowed detector read-out modes listed on the FORS1/FORS2 Phase 2 Web pages? [NA] [FORS only] Do all your FORS MOS/LSS OBs contain the mandatory "through-slit image" template? [NA] [UVES only] Do all your UVES OBs use only the allowed templates listed on the UVES Phase 2 Web pages ? [Y] [ISAAC only] Are ALL the objects in your field-of-view fainter than the magnitude limits specified on the ISAAC Phase 2 Web page ? [NA] [ISAAC only] If you submitted OBs for standard stars, did you use the provided StandardStar templates? [NA] [FLAMES only] Did you specify the hour angle range for which your Target Setup files are valid ? [NA] [WFI only]Are your finding charts 34 arcmin x 34 arcmin? [NA] If you answered "NO" to any of these questions, please revise your OBs *before* submission.