README Template 69.1 ESO Programme ID: 69.A-0555(A) Principal Investigator Name: Alain SMETTE Principal Investigator E-mail Address: Alain.Smette@ulg.ac.be Principal Investigator Telephone Number: +32-4-366 97 64 Instrument: UVES OPC Priority Class: A OPC Approved Total Execution Time: 38h Estimated Total Execution Time (including overheads): 37h37m30s README File Submission Date: Programme Description ===================== General Overview ---------------- UVES observations of (I) a z = 2.08 double quasar (Q1429-008 A/B) (II) a z = 2.15 double quasar (Q2345+007 A/B) Both systems are either binary or lensed quasars. Both components in each system will be observed with the aim of reaching comparable S/N ratio. (I) Q1429-008 A and B """""""""""""" There is 3 magnitudes of difference between the two components of the pair. This difference can be variable. As one can see in the finding charts, there is no other point-like objects nearby (but many faint galaxies). A is the bright component, with V = 17.7. B has therefore V = 20.7. The separation is 5.13arcsec, the Position Angle of B relative to A is 300 degrees, North through East. The whole spectral range will be covered by the UVES observations in two set-ups: Dichroic 1 will be used with CD#2, l_c = 390 and CD#3, l_c = 564 Dichroic 2 will be used with CD#2, l_c = 437 and CD#3, l_c = 860 The first set-up aims at covering the Ly-alpha forest as much to the UV as possible, and will be limited by the object faintness and read-out noise. Therefore, 6 long exposures are planned (6600s) for the B components. On the other hand, 2 1500s exposures of the A component will be carried out. For the 2nd set-up, one should not be read-out noise limited, therefore 4 exposures of 3000s are planned for B, while 2 1500s exposures of A will be carried out. The observations for the A component (seeing 0.8 arcsec) are less strict as for B (0.6 arcsec). The name for the OBs are: Q1429 // either "A" or "B" // either "-s1-" or "-s2" // discriminating number, where "-s1-" is for Dichroic 1 observations "-s2-" is for Dichroic 2 observations The following sequence is suggested: OB: Priority: --- --------- Q1429A-S1-0 1 Q1429B-S1-0 1 Q1429B-S1-1 1 Q1429B-S1-2 1 Q1429A-S2-0 1 Q1429B-S2-0 1 Q1429B-S2-1 1 Q1429B-S1-3 2 Q1429B-S1-4 2 Q1429B-S2-2 2 Q1429B-S2-3 2 Q1429B-S1-5 3 (II) Q2345+007: """"""""""""""" There is a ratio of 3.3 in flux between the two objects, but this ratio is variable. The spectral domain covers a large fraction of the Ly-alpha forest and all but ~ 100A of the region between the Ly-alpha and the CIV emission lines. Q2345+007A is the brighest component: B = 19.3, R = 18.8. It can be variable. VLT should be able to point on it with the required seeing conditions. It will also be used as offset star for Q2345+007B. A total of 4h of integration (2 hours in priority 2 + 2 hours in priority 4) is requested. Q2345+007B is located 5.86 arcsec West and 3.94 South of Q2345+007A. It has B = 20.6 and R = 20.0. It can be variable. A total of 16 hours of exposure time (8 hours in priority 1 + 8 hours in priority 2) is requested. Suggested sequence is, however the constraints are less strong on component A than on component B. Q2345+007B-0 Q2345+007B-1 Q2345+007B-2 Q2345+007B-3 Q2345+007A-0 Q2345+007B-4 Q2345+007B-5 Q2345+007B-6 Q2345+007B-7 Q2345+007A-1 Waiver Request Summary ---------------------- We have requested the possibility to use OBs with 2hour integration time + overheads: WaiverID 69.A-0555A.01. The request was submitted on Feb 19, 2001 and accepted on Feb 21, 2002. Critical Observing Condition Constraints ---------------------------------------- This program requires very good conditions. Due to the faintness of the objects, a seeing better than 0.6arcsec during the time of the observations is requested for most OBs, except for two defined to observe Q1429A. It should not degrade worst than 0.8 arcsec. Since most OBs correspond to UV observations, airmass is also critical. Absence or very little amount of moonlight is also requested, especially for Q2345+007B and Q1429-0053B. For the same reasons, the slit must be oriented at the parallactic angle. The slit orientation given in the finding charts is only indicative of the general orientation of the objects. Time Critical Aspects --------------------- None Special Calibration Information ------------------------------- None ToO Information --------------- This is not a ToO programme. Pre-Imaging Information ----------------------- No pre-imaging is required for this programme. OB Information ============== List of Science OBs with Associated Finding Charts -------------------------------------------------- Total Number of Submitted Science OBs: 22 Total Number of Submitted Finding Charts: 6 For Q1429-0053A: 69.A-0555A.005.ps: 1 arcmin field For Q1429-0053B: 69.A-0555A.006.ps: 1 arcmin field For Q2345+007A 69.A-0555A.001.ps: 6 arcmin field 69.A-0555A.002.ps: 1 arcmin field For Q2345+007B: 69.A-0555B.003.ps: 6 arcmin field 69.A-0555B.004.ps: 1 arcmin field Note: Q2345+007A is also the offset star for Q2345+007B Q1429A-S1-0 = 69.A-0555A.005.ps Q1429A-S2-0 = 69.A-0555A.005.ps Q1429B-S1-0 = 69.A-0555A.006.ps Q1429B-S1-1 = 69.A-0555A.006.ps Q1429B-S1-2 = 69.A-0555A.006.ps Q1429B-S1-3 = 69.A-0555A.006.ps Q1429B-S1-4 = 69.A-0555A.006.ps Q1429B-S1-5 = 69.A-0555A.006.ps Q1429B-S2-0 = 69.A-0555A.006.ps Q1429B-S2-1 = 69.A-0555A.006.ps Q1429B-S2-2 = 69.A-0555A.006.ps Q1429B-S2-3 = 69.A-0555A.006.ps Q2345+007A-0 = 69.A-0555A.001.ps = 69.A-0555A.002.ps Q2345+007A-1 = 69.A-0555A.001.ps = 69.A-0555A.002.ps Q2345+007B-0 = 69.A-0555A.003.ps = 69.A-0555A.004.ps Q2345+007B-1 = 69.A-0555A.003.ps = 69.A-0555A.004.ps Q2345+007B-2 = 69.A-0555A.003.ps = 69.A-0555A.004.ps Q2345+007B-3 = 69.A-0555A.003.ps = 69.A-0555A.004.ps Q2345+007B-4 = 69.A-0555A.003.ps = 69.A-0555A.004.ps Q2345+007B-5 = 69.A-0555A.003.ps = 69.A-0555A.004.ps Q2345+007B-6 = 69.A-0555A.003.ps = 69.A-0555A.004.ps Q2345+007B-7 = 69.A-0555A.003.ps = 69.A-0555A.004.ps List of Calibration OBs with Associated Science OBs --------------------------------------------------- Total Number of Submitted Calibration OBs: 0 OB Compliance Checks ==================== Y = Yes, N = No, NA = Not Applicable Do all your OBs comply with the instrument specific requirements listed on the instrument specific Phase 2 Web pages [Y/N/NA]? Y Do all your FORS OBs use only the allowed detector read-out modes listed on the FORS1/FORS2 Phase 2 Web pages? [Y/N/NA] NA Do all your FORS MOS/LSS OBs contain the mandatory "through-slit image" template? [Y/N/NA]? NA Do all your UVES OBs use only the allowed templates listed on the UVES Phase 2 Web pages [Y/N/NA]? Y If you submitted OBs for standard stars, did you specify the magnitude and spectral type of all standard stars [Y/N/NA]? NA [ISAAC only] Are ALL the objects in your field-of-view fainter than the magnitude limits specified on the ISAAC Phase 2 Web page [Y/N/NA]? NA [ISAAC only] If you submitted OBs for standard stars, did you use the provided StandardStar templates? [Y/N/NA]? NA If you answered "NO" to any of these questions, please revise your OBs *before* submission. Destination Address for Data Products ===================================== Alain SMETTE Institut d'Astrophysique et de Géophysique Université de Liège, Bât. B5C, Room 2/10 Allée du 6 Août, 17, B-4000 Liège, Belgium Tél.: 32-(0)4-366 97 64 Sec.: 32-(0)4-366 97 16 Fax : 32-(0)4-366 97 46