README Template 68.1 ESO Programme ID: 68.A-0625(A) Principal Investigator: Smette Contact Person Name: Alain Smette Contact Person E-mail Address: smette@astro.ulg.ac.be Contact Person Telephone Number: +32-4-254 75 64 Instrument: UVES OPC Priority Class: B OPC Approved Total Execution Time: 12.0 Estimated Total Execution Time (including overheads): 11.9 README File Submission Date: 14 August 2001 Revised README File Submission Date: 17 September 2001 Programme Description ===================== General Overview ---------------- With these observations, we want to study the small scale structure of a galaxy at a redshift = 4. For this, we use UVES to obtain the spectra of the two component of a z = 4.5 gravitationally lensed system. The two components, separated by 1", are observed together: they will appear together in the slit. Two settings are used in order to cover the whole range accessible. It is certain that a large fraction of the blue setting will not give any signal due to the presence of intergalactic absorption at high redshift. The separation between the two components in RA and delta are: RA(B) - RA(A) = -0.696" delta(B) - delta(A) = -0.709" Waiver Request Summary ---------------------- We have requested to use OBs with 2 hour exposures. This request was submitted on 13 August 2001 and approved on 13 August 2001. Note however, that we finally decided to use 3000s exposures. Critical Observing Condition Constraints ---------------------------------------- The two components should both be visible within the slits, although the faint component will be difficult. We would like to have the faint component at the center of the slit. so that we are sure that it will be well centered. The value of the PA then insures that the bright one will be in the slit also. If, for some reason, the PA is not perfect (because people using the HST had made a small error for example), then this approach insures that the faint component will still be well in the slit. Although the bright one will not be so well centered, the slit width should insure that there is no major loss of flux, and, being bright, a sufficient S/N will be obtained. In practice, centering should be done using the bright, R= 19.2, A component. Once done, use the blind offset to center the faint, R = 20.5, B component Time Critical Aspects --------------------- None Special Calibration Information ------------------------------- None ToO Information --------------- This is not a ToO programme. Pre-Imaging Information ----------------------- No pre-imaging is required for this programme. OB Information ============== List of Science OBs with Associated Finding Charts -------------------------------------------------- Total Number of Submitted Science OBs: 12 Total Number of Submitted Finding Charts: 2 For all OBs, we provide 2 finding charts: one with a large field (5 arcmin across): 68.A-0625A.001.ps one image obtained with HST, with a scale of 1" shown : 68.A-0625A.002.ps The slit must be aligned along the two A and B components (a galaxy can be seen in the finding chart 68.A-0625A.002.ps, between the two components. It will not affect the observations). OB_Q0952-580-0.obx OB_Q0952-580-1.obx OB_Q0952-580-2.obx OB_Q0952-580-3.obx OB_Q0952-580-4.obx OB_Q0952-580-5.obx OB_Q0952-DIC2-0.obx OB_Q0952-DIC2-1.obx OB_Q0952-DIC2-2.obx OB_Q0952-DIC2-3.obx OB_Q0952-DIC2-4.obx OB_Q0952-DIC2-5.obx List of Calibration OBs with Associated Science OBs --------------------------------------------------- Number of Submitted Calibration OBs: 0 OB Compliance Checks ==================== Y = Yes, N = No, NA = Not Applicable Do all your OBs comply with the instrument specific requirements listed on the instrument specific Phase 2 Web pages [Y]? Y Do all your FORS OBs use only the allowed detector read-out modes listed on the FORS1/FORS2 Phase 2 Web pages? [NA] Do all your FORS MOS/LSS OBs contain the mandatory "through-slit image" template? [NA]? Do all your UVES OBs use only the allowed templates listed on the UVES Phase 2 Web pages [NA]? Y If you submitted OBs for standard stars, did you specify the magnitude and spectral type of all standard stars [NA]? [ISAAC only] Are ALL the objects in your field-of-view fainter than the magnitude limits specified on the ISAAC Phase 2 Web page [NA]? [ISAAC only] If you submitted OBs for standard stars, did you use the provided StandardStar templates? [NA]? If you answered "NO" to any of these questions, please revise your OBs *before* submission. Destination Address for Data Products ===================================== Dr. Alain SMETTE Institut d'Astrophysique et de Geophysique Universite de Liege Avenue de Cointe, 5 B-4000 Liege Belgium *************************************** DO NOT WRITE BELOW THESE LINES!!!!!!!!! ***************************************