README Template 68.1 ESO Programme ID: 6801820 Principal Investigator: A. Cimatti Contact Person Name: A. Cimatti Contact Person E-mail Address: cimatti@arcetri.astro.it Contact Person Telephone Number: +39-055-2752-297 Instrument: FORS2 OPC Priority Class: A OPC Approved Total Execution Time: 20.8 Estimated Total Execution Time (including overheads): 20.8 README File Submission Date: 8 August 2001 Programme Description ===================== General Overview ---------------- The program consists in deep integrations of the same field taken in: - slitless spectroscopy with grism 600z + filter z_SPECIAL+43 (8.4 hours) - imaging with filter z_SPECIAL+43 (5.9 hours) - imaging with filter I (3.2 hours) Priorities are ranked as follows: 1) Slitless spectroscopy AND z_special imaging (equal priority). 2) I-band imaging. However, we emphasize that the full success of the project can be reached only if all three observations are made. Waiver Request Summary ---------------------- We submitted a waiver request on 6 august 2001 in order to use the CCD readout mode ABCD,1x1,high also for the slitless spectroscopy data instead of the mode A,1x1,high. The motivation was to reduce by a factor of 2 the overhead times and therefore to have the possibility to obtain a large number of frames each with a rather short integration time (~5-6 minutes) in order to remove efficiently the fringing pattern and the sky variations. Such a request was approved on 8 august 2001 (email message received from M. Romaniello). Critical Observing Condition Constraints ---------------------------------------- Since we aim at detecting very faint emission lines, it is essential that the observations are made during low airmass, dark moon and seeing < 0.7". Time Critical Aspects --------------------- Special Calibration Information ------------------------------- Our program requires both standard and non-standard calibrations. STANDARD CALIBRATIONS: - Bias images (imaging & spectroscopy) - Dark images (imaging & spectroscopy) - Sky flats (imaging) with filters Bessel I and z_SPECIAL+43 - Photometric standard stars with filter Bessel I (imaging) - Spectrophotometric standard star(s) with filter z_SPECIAL+43 (imaging) (see note *). NON-STANDARD CALIBRATIONS: DAY-TIME CALIBRATIONS: - Sky twilight flats with grism 600z+z_SPECIAL+43 (SLITLESS MODE) (note **) - Wavelength calibration with grism 600z+z_SPECIAL+43 in MOS mode (7 OBs) (see note ***) NIGHT-TIME CALIBRATION: - Spectrophotometric standard star in SLITLESS mode with grism 600z + filter z_SPECIAL+43 (see note ****) FREQUENCY OF NON-STANDARD CALIBRATIONS DURING THE WHOLE PERIOD OF OUR OBSERVATIONS: - spectrophotometric standard star: only once - sky twilight flats, wavelength cal.: enough to cover the whole period during which the observations of our program are distributed (e.g. two times: one in the beginning and one at the end). NOTES: (*) We will need the observations of photometric standard stars appropriate for the z_SPECIAL+43 filter imaging. Since there are not photometric standard stars for that filter, we suggest to use the spectrophotometric standards of Hamuy et al. (1992,1994) based on the AB magnitude system and extended to 10300 AA. (**) We prepared an OB for the sky twilight flats (slitless spec. mode with grism 600z + filter z_SPECIAL+43). However we could not set neither specific coordinates nor the correct integration time. Please set them during the observations reminding that we need a mean level of 20000-30000 ADU per flat field image. Such calibrations will be done during twilight time and they won't interfer with our scientific night-time program. (***) The OBs for MOS lambda calibrations are needed to map the wavelength calibration and the distorsions in the FORS2 field (such calibrations will be taken during the day). Please note that in this calibration set there are also images taken without the grism that are crucial for associating a (X,Y) position to each lamp spectrum. The useful lamps are the Argon I and Neon I lamps with 4 lines falling into the wavelength range of the filter. IMPORTANT: since the appropriate integration times have not been yet determined for these lamps used with the grism 600z (according to the FORS manual) PLEASE CHECK THAT THE LINES ARE NOT SATURATED AND WELL VISIBLE (at least the 2 central ones, falling near the peak of the filter z special). (****) Such a calibration will take some of our allocated night-time observations. The integration time was estimated with the ESO ETC. However, PLEASE CHECK THAT SUCH TIME IS CORRECT, i.e. providing about 10000 -- 30000 ADU per pixel at the peak of the star spectrum. The selected star is: HD 60753 07:33:27.26 -50:35:03.7 J2000 B3IV V=6.60 ToO Information --------------- Pre-Imaging Information ----------------------- OB Information ============== List of Science OBs with Associated Finding Charts -------------------------------------------------- Total Number of Submitted Science OBs: 22 Total Number of Submitted Finding Charts: 2 ZERO 04h-field Bessel I imaging = 68.A-0182A.001.ps 04h-field Bessel I imaging-2 = 68.A-0182A.001.ps 04h-field Bessel I imaging-3 = 68.A-0182A.001.ps 04h-field Bessel I imaging-4 = 68.A-0182A.001.ps ZERO 04h-field z_special imaging = 68.A-0182A.001.ps 04h-field z_special imaging-2 = 68.A-0182A.001.ps 04h-field z_special imaging-3 = 68.A-0182A.001.ps 04h-field z_special imaging-4 = 68.A-0182A.001.ps 04h-field z_special imaging-5 = 68.A-0182A.001.ps 04h-field z_special imaging-6 = 68.A-0182A.001.ps 04h-field z_special imaging-7 = 68.A-0182A.001.ps ZERO 4h-f slitless 600z+z_spec = 68.A-0182A.001.ps 4h-f slitless 600z+z_special-2 = 68.A-0182A.001.ps 4h-f slitless 600z+z_special-3 = 68.A-0182A.001.ps 4h-f slitless 600z+z_special-4 = 68.A-0182A.001.ps 4h-f slitless 600z+z_special-5 = 68.A-0182A.001.ps 4h-f slitless 600z+z_special-6 = 68.A-0182A.001.ps 4h-f slitless 600z+z_special-7 = 68.A-0182A.001.ps 4h-f slitless 600z+z_special-8 = 68.A-0182A.001.ps 4h-f slitless 600z+z_special-9 = 68.A-0182A.001.ps 4h-f slitless 600z+z_special-10 = 68.A-0182A.001.ps ZERO SpecPhot HD60753 Slitless = 68.A-0182A.002.ps List of Calibration OBs with Associated Science OBs --------------------------------------------------- SkyFlat slitless 600z+z_special Wave slit 1 Wave slit 2 Wave slit 3 Wave slit 4 Wave slit 5 Wave slit 6 Wave slit 7 Total Number of Submitted Calibration OBs: 8 OB Compliance Checks ==================== Y = Yes, N = No, NA = Not Applicable Do all your OBs comply with the instrument specific requirements listed on the instrument specific Phase 2 Web pages [Y]? Do all your FORS OBs use only the allowed detector read-out modes listed on the FORS1/FORS2 Phase 2 Web pages? [Y-see waiver request] Do all your FORS MOS/LSS OBs contain the mandatory "through-slit image" template? [NA]? Do all your UVES OBs use only the allowed templates listed on the UVES Phase 2 Web pages [NA]? If you submitted OBs for standard stars, did you specify the magnitude and spectral type of all standard stars [Y]? [ISAAC only] Are ALL the objects in your field-of-view fainter than the magnitude limits specified on the ISAAC Phase 2 Web page [NA]? [ISAAC only] If you submitted OBs for standard stars, did you use the provided StandardStar templates? [Y]? If you answered "NO" to any of these questions, please revise your OBs *before* submission. Destination Address for Data Products ===================================== Andrea Cimatti Osservatorio Astrofisico di Arcetri Largo E. Fermi 5 I-50125 Firenze Italy *************************************** DO NOT WRITE BELOW THESE LINES!!!!!!!!! ***************************************