README Template 72.1 (please do not delete the README Template Version line!) ESO Programme ID: : 072.C-0689(A) Principal Investigator Name : Mark McCaughrean Principal Investigator E-mail Address : mjm@aip.de Principal Investigator Telephone Number : +49 (0)331 749 9525 Principal Investigator Postal Address : Astrophysikalisches Institut Potsdam An der Sternwarte 16 14482 Potsdam, Germany Instrument: : NACO OPC Priority Class: : A OPC Approved Total Execution Time : 4.0 hours Estimated Total Execution Time (including overheads) : 4.0 hours (see below) README File Submission Date: 22nd October 2003 Programme Description ===================== General Overview ---------------- This is one part of a complex program of ISAAC, FORS2, and NACO imaging and spectroscopy observations of Eps Indi Ba,Bb, the nearest known binary brown dwarf / T dwarf system. The binary has a separation of 0.732 arcsec at a position angle 137 degrees E of N. The system also has a very high proper motion of 4.7 arcsec/yr. This part of the program covers NACO imaging in the H band. The N90C10 dichroic is used throughout, with IR wavefront sensing on the brighter of the two T dwarfs, Eps Indi Ba, which has H=11.51. A frequency of 115Hz in the IR WFS ensures the very good correction necessary to get a good Strehl ratio and suppress the speckle halo, thus enabling detection of faint, low mass sources close to the T dwarfs. Any optimisation that is done during the observations should concentrate on improving these parameters. There is one relatively short OB using the S13 camera to get accurate relative positions for the two components, as part of an orbital motion monitoring campaign. There is an accompanying OB using the same NACO configuration to measure the image scale and orientation using an astrometric binary, WDS 01559+0151, V=6.01/6.1, late F type, separation 0.94 arcsec at epoch 2003.8. The NACO observations of this bright binary are taken through the H filter in tandem with neutral density filter ND_short, in order to reduce the flux incident on the NACO science detector. There are also 3 OBs intended for deep imaging of Eps Indi Ba,Bb and their surroundings, in search of potentially lower mass companions to 4Mjup. The NACO S27 camera is used with longer on-chip integration times (27 secs) to increase the S/N: under exceptional conditions, Eps Indi Ba may saturate at H, but this is not a major concern. Each of the long OBs consists of a series of dithered images: the total execution time for each OB is 1 hour. Again, there is a calibration OB to measure the image scale and orientation using the same astrometric binary, WDS 01559+0151. IMPORTANT: The long, deep OBs (and calibration) should all be taken together on the same night, if at all possible. The orbital motion of Eps Indi Bb around Ba is roughly 2 degrees/month, and thus the data cannot be coadded effectively if taken more than a few days apart. The short, shallow orbital motion monitoring OBs can be taken on another night, if necessary, although again, the Eps Indi Ba,Bb and WDS 01559+0151 S13 OBs must be taken close together in time. The associated finding chart shows a 30x30 arcsec section from the 2MASS quick-look J atlas taken in 1999.86. Eps Indi B is seen as a single source: an inset image shows a NACO image (5x5 arcsec) in the H-band which shows it as a resolved binary. IMPORTANT: As Eps Indi Ba,Bb moves at 4.7 arcsec per year, it will have moved roughly 15 arcsec since the 2MASS data were taken. The present-day (epoch 2003.8) position of Eps Indi Ba,Bb is marked on the finding chart with an open circle. Proper motions are indicated on the finding chart and are included in the target part of the OD. Further finding charts from the DSS and FORS1 are attached to other runs in this program. Approved Waiver Request Summary ------------------------------- None. Critical Observing Condition Constraints ---------------------------------------- IMPORTANT: The original proposal requested 1 arcsec seeing, before it was known that Eps Indi B is a binary. We have thus requested and been granted permission to upgrade our observations to have a constraint of 0.6 arcsec seeing or better, in order to be able to separate the two sources. The better the seeing we can get, the better the results. Clear conditions are required. No particularly strong requirements are placed on lunar illumination or distance of the moon from the target. Time Critical Aspects --------------------- None Special Calibration Information ------------------------------- We have provided OBs for measurements of an astrometric binary standard for measuring the image scale and orientation. There are OBs for the S13 and S27 cameras which should be taken as close in time as possible (i.e. without any adjustment of the NACO instrument and mounting) to the Eps Indi Ba,Bb OBs in the corresponding cameras. ToO Information --------------- No ToO observations are requested. Pre-Imaging Information ----------------------- No preimaging is required for this programme. OB Information ============== List of Science OBs with Associated Finding Charts -------------------------------------------------- Total Number of Submitted Science OBs: 4 Total Number of Submitted Finding Charts: 1 epsindib_naco_h_s13_short = 072.C-0689F.001.ps epsindib_naco_h_s27_long1 = 072.C-0689F.001.ps epsindib_naco_h_s27_long2 = 072.C-0689F.001.ps epsindib_naco_h_s27_long3 = 072.C-0689F.001.ps List of Calibration OBs with Associated Science OBs --------------------------------------------------- Total Number of Submitted Calibration OBs: 2 wds01559_naco_h_s13 = associated with epsindib_naco_h_s13_short wds01559_naco_h_s27 = associated with epsindib_naco_h_s27_long1,2,3 Finding chart for these calibrator OBs is 072.C-0689F.002.ps Phase 2 package Compliance Checks ================================= (Y = Yes, N = No, NA = Not Applicable) Do all your OBs comply with the instrument specific requirements listed on the instrument specific Phase 2 Web pages ? [Y/N/NA] Y Do all your Finding Charts comply with the both the general and instrument-specific finding chart requirements? [Y/N/NA] Y If you submitted OBs for standard stars, did you specify the magnitude and spectral type of all standard stars ? [Y/N/NA] NA Have you included OBs for any calibrations that you need but which are not a part of the Calibration Plan? [Y/N/NA] Y [FORS only] Do all your FORS OBs use only the allowed detector read-out modes listed on the FORS1/FORS2 Phase 2 Web pages? [Y/N/NA] NA [FORS only] Do all your FORS MOS/LSS OBs contain the mandatory "through-slit image" template? [Y/N/NA] NA [UVES only] Do all your UVES OBs use only the allowed templates listed on the UVES Phase 2 Web pages ? [Y/N/NA] NA [ISAAC only] Are ALL the objects in your field-of-view fainter than the magnitude limits specified on the ISAAC Phase 2 Web page ? [Y/N/NA] Y [ISAAC only] If you submitted OBs for standard stars, did you use the provided ISAAC*_*_cal_* templates? [Y/N/NA] Y [FLAMES only] Did you specify the hour angle range for which your Target Setup files are valid ? [Y/N/NA] NA [VIMOS only] Did you specify suitable guide stars for all your OBs using Guidecam? [Y/N/NA] NA [VIMOS only] Did you check that the chosen guide stars are suitable for all the offset positions and that they do not produce unacceptable vignetting of the field of view? [Y/N/NA] NA If you answered "NO" to any of these questions, please revise your OBs *before* submission.