CCD SPARC reboot ( wemcr, wemcs,
wefcs wcecs wodt5 ):
Important notice about FIERA system with the VLTSW MAR2002 distribution.
A bug causes the following symptom: when rebooting the FIERA SPARC (wodt5,wemcs,wemcr,wefcs
or wcecs), the FIERA system will hang without any error message.
The workaround consists in stop/start the CCS environment immediately after
a reboot of the FIERA SPARC.
Therefore :
1. Do NOT reboot the SPARC as a standard start-up procedure. Reboot the SPARC
only if there is a problem.
2. If you need to reboot the SPARC anyhow, perform the following procedure:
- - After the reboot (wait a few minutes), login to the SPARC as fcdrun, rlogin
w-- -l fcdrun
- - change to user vltmgr, issuing
- > su - vltmgr - check if the CCS environment is running, issuing (make
sure to set the DISPLAY variable)
- > ccsPerfMon
- - if the environment is not running (that means automatic start-up of the
CCS environment is disabled) start, stop and start it again, issuing
- > vccEnvStart -e $RTAPENV ...wait around 30 seconds...
- > vccEnvStop -e $RTAPENV ... wait around 10 seconds ...
- > vccEnvStart -e $RTAPENV ... wait around 30 seconds ....
- - if the environment is running (that means automatic start-up of the CCS
environment is enabled) stop it and start it again, issuing
- > vccEnvStop -e $RTAPENV ... wait around 10 sec ...
- > vccEnvStart -e $RTAPENV ... wait around 30 sec ...
- - Afterwards, start the FIERA processes, issuing the corresponding command
in the Instrument WS, i.e.,
- > nttinsStartSCCDS emr (for NTT-EMMI RED)
- > nttinsStartSCCDS susi (for NTT-SUSI)
- > efinsStartSCCDS (for 3.60-EFOSC)
- > ceinsStartSCCDS (for 3.60-CES)
- > fcdStartWFOV.sh (for 2p2-WFI)
This problem is under investigation by Garching group. As soon as we have the
solution, we'll inform you.