*** MIDAS logfile (05SEPpl1.2) *** Su, 01 Oct 2006 15:53:56 Page 1 *** MIDAS logfile (vers. 05SEPpl1.2) *** Su, 01 Oct 2006 15:54:10 Page 2 ========================================================== SUMMARY STANDARD TEST CCD#46 TAKEN ON 061001 IN normcd MODE ========================================================== BIAS ==== 5 biases at start test: average = 348.89 stddev = 2.17 FIERA temperature = 273.15 K There were 0 hot pixels/columns detected TRANSFER FUNCTION AND LINEARITY DATA ==================================== Table : Std_normcd_46_061001 Sequence Exp_tim1 Med_cnt1 Med_cnt2 Variance Frc_cnt1 Frc_cnt2 el_adu1 -------- --------- --------- --------- --------- --------- --------- --------- 1 2.17 1701.6 1701.0 877.3 0.12 0.12 1.94 2 4.34 3390.2 3390.1 1683.8 -0.20 -0.19 2.01 3 8.67 6786.0 6784.6 3339.1 -0.06 -0.07 2.03 4 13.00 10175.0 10174.7 5031.3 -0.09 -0.09 2.02 5 19.51 15267.9 15267.8 7574.9 -0.05 -0.05 2.02 6 26.01 20366.0 20365.6 9901.1 -0.00 -0.00 2.06 7 32.51 25468.2 25467.1 12351.0 0.04 0.04 2.06 8 43.34 33972.6 33974.5 16320.1 0.09 0.09 2.08 9 54.17 42471.1 42470.7 20207.4 0.10 0.10 2.10 10 65.01 50942.8 50943.9 23362.3 0.06 0.06 2.18 -------- --------- --------- --------- --------- --------- --------- --------- Dynamic range explored: from 3669 to 109871 e- Average count rate measured: 783 ADU/sec. CONV. FACTOR AND RON ==================== C.Fact = 2.16 +/- 0.03 e-/ADU RON = 4.69 +/- 0.06 e- RMS SHUTTER ERROR ============= Average shutter error derived from fractional count rate = -0.001 sec LINEARITY ERROR =============== Average linearity error after shutter correct. = + 0.12/-0.20 % These errors represent maximum deviation in % from the average count rate after correction for shutter delay