*** MIDAS logfile (05SEPpl1.2) *** Sa, 01 Mar 2008 14:33:10 Page 1 *** MIDAS logfile (vers. 05SEPpl1.2) *** Sa, 01 Mar 2008 14:33:24 Page 2 ========================================================== SUMMARY STANDARD TEST CCD#46 TAKEN ON 080301 IN fastcd MODE ========================================================== BIAS ==== 5 biases at start test: average = 283.96 stddev = 1.97 FIERA temperature = 273.15 K There were 0 hot pixels/columns detected TRANSFER FUNCTION AND LINEARITY DATA ==================================== Table : Std_fastcd_46_080301 Sequence Exp_tim1 Med_cnt1 Med_cnt2 Variance Frc_cnt1 Frc_cnt2 el_adu1 -------- --------- --------- --------- --------- --------- --------- --------- 1 0.55 1593.0 1592.0 788.1 0.08 0.09 2.02 2 1.09 3170.1 3171.1 1569.2 -0.18 -0.15 2.02 3 2.17 6353.8 6354.4 3156.3 0.07 0.07 2.01 4 3.25 9514.0 9513.6 4877.0 -0.08 -0.09 1.95 5 4.88 14287.0 14284.9 7251.3 0.04 0.03 1.97 6 6.50 19030.6 19034.3 9284.4 -0.06 -0.05 2.05 7 8.13 23811.6 23809.8 12047.3 0.04 0.03 1.98 8 10.84 31731.6 31735.2 16041.8 0.00 0.00 1.98 9 13.55 39674.9 39681.1 19446.9 0.03 0.03 2.04 10 16.25 47619.3 47618.2 23596.4 0.05 0.04 2.02 -------- --------- --------- --------- --------- --------- --------- --------- Dynamic range explored: from 3219 to 96268 e- Average count rate measured: 2929 ADU/sec. CONV. FACTOR AND RON ==================== C.Fact = 2.02 +/- 0.02 e-/ADU RON = 3.97 +/- 0.03 e- RMS SHUTTER ERROR ============= Average shutter error derived from fractional count rate = -0.002 sec LINEARITY ERROR =============== Average linearity error after shutter correct. = + 0.09/-0.17 % These errors represent maximum deviation in % from the average count rate after correction for shutter delay