*** MIDAS logfile (05SEPpl1.2) *** Mo, 29 Oct 2007 12:00:16 Page 1 *** MIDAS logfile (vers. 05SEPpl1.2) *** Mo, 29 Oct 2007 12:00:30 Page 2 ========================================================== SUMMARY STANDARD TEST CCD#46 TAKEN ON 071029 IN fastcd MODE ========================================================== BIAS ==== 5 biases at start test: average = 284.61 stddev = 1.98 FIERA temperature = 273.15 K There were 0 hot pixels/columns detected TRANSFER FUNCTION AND LINEARITY DATA ==================================== Table : Std_fastcd_46_071029 Sequence Exp_tim1 Med_cnt1 Med_cnt2 Variance Frc_cnt1 Frc_cnt2 el_adu1 -------- --------- --------- --------- --------- --------- --------- --------- 1 0.55 1597.3 1598.6 838.6 0.12 0.04 1.90 2 1.09 3183.8 3185.6 1583.8 -0.12 -0.16 2.01 3 2.17 6385.8 6386.9 3204.5 0.11 0.10 1.99 4 3.25 9558.3 9557.1 4964.9 -0.08 -0.08 1.93 5 4.88 14350.5 14351.8 7283.4 0.02 0.03 1.97 6 6.50 19118.3 19118.9 9702.4 -0.07 -0.06 1.97 7 8.13 23920.7 23921.8 12142.5 0.02 0.04 1.97 8 10.84 31877.5 31877.5 16025.8 -0.02 -0.00 1.99 9 13.55 39852.7 39859.6 19705.7 -0.01 0.03 2.02 10 16.25 47839.5 47840.8 23238.7 0.03 0.05 2.06 -------- --------- --------- --------- --------- --------- --------- --------- Dynamic range explored: from 3268 to 97840 e- Average count rate measured: 2943 ADU/sec. CONV. FACTOR AND RON ==================== C.Fact = 2.05 +/- 0.02 e-/ADU RON = 4.05 +/- 0.04 e- RMS SHUTTER ERROR ============= Average shutter error derived from fractional count rate = -0.003 sec LINEARITY ERROR =============== Average linearity error after shutter correct. = + 0.11/-0.14 % These errors represent maximum deviation in % from the average count rate after correction for shutter delay