*** MIDAS logfile (05SEPpl1.2) *** Th, 02 Aug 2007 15:37:22 Page 1 *** MIDAS logfile (vers. 05SEPpl1.2) *** Th, 02 Aug 2007 15:37:36 Page 2 ========================================================== SUMMARY STANDARD TEST CCD#46 TAKEN ON 070802 IN fastcd MODE ========================================================== BIAS ==== 5 biases at start test: average = 285.21 stddev = 1.97 FIERA temperature = 273.15 K There were 0 hot pixels/columns detected TRANSFER FUNCTION AND LINEARITY DATA ==================================== Table : Std_fastcd_46_070802 Sequence Exp_tim1 Med_cnt1 Med_cnt2 Variance Frc_cnt1 Frc_cnt2 el_adu1 -------- --------- --------- --------- --------- --------- --------- --------- 1 0.55 1609.6 1611.3 804.4 0.03 0.09 2.00 2 1.09 3206.9 3210.7 1630.9 -0.17 -0.12 1.97 3 2.17 6431.3 6429.5 3232.8 0.09 0.07 1.99 4 3.25 9626.8 9628.6 4924.9 -0.07 -0.08 1.95 5 4.88 14455.7 14453.9 7360.6 0.05 0.02 1.96 6 6.50 19255.8 19256.5 9562.9 -0.05 -0.06 2.01 7 8.13 24088.3 24091.6 12029.8 0.03 0.03 2.00 8 10.84 32107.5 32107.1 16229.7 0.01 -0.01 1.98 9 13.55 40140.2 40143.8 19666.1 0.03 0.01 2.04 10 16.25 48181.2 48185.8 24182.7 0.05 0.05 1.99 -------- --------- --------- --------- --------- --------- --------- --------- Dynamic range explored: from 3238 to 96873 e- Average count rate measured: 2963 ADU/sec. CONV. FACTOR AND RON ==================== C.Fact = 2.01 +/- 0.01 e-/ADU RON = 3.97 +/- 0.03 e- RMS SHUTTER ERROR ============= Average shutter error derived from fractional count rate = -0.002 sec LINEARITY ERROR =============== Average linearity error after shutter correct. = + 0.09/-0.14 % These errors represent maximum deviation in % from the average count rate after correction for shutter delay