*** MIDAS logfile (05SEPpl1.2) *** Th, 12 Oct 2006 16:52:09 Page 1 *** MIDAS logfile (vers. 05SEPpl1.2) *** Th, 12 Oct 2006 16:52:23 Page 2 ========================================================== SUMMARY STANDARD TEST CCD#46 TAKEN ON 061012 IN fastcd MODE ========================================================== BIAS ==== 5 biases at start test: average = 284.25 stddev = 2.00 FIERA temperature = 273.15 K There were 0 hot pixels/columns detected TRANSFER FUNCTION AND LINEARITY DATA ==================================== Table : Std_fastcd_46_061012 Sequence Exp_tim1 Med_cnt1 Med_cnt2 Variance Frc_cnt1 Frc_cnt2 el_adu1 -------- --------- --------- --------- --------- --------- --------- --------- 1 0.55 1710.5 1710.7 840.6 0.00 0.02 2.03 2 1.09 3407.1 3403.9 1898.7 -0.16 -0.21 1.79 3 2.17 6826.5 6824.6 3464.1 0.10 0.09 1.97 4 3.25 10216.6 10217.5 5257.5 -0.07 -0.06 1.94 5 4.88 15338.7 15338.8 7603.9 0.05 0.06 2.02 6 6.50 20431.5 20434.6 10220.7 -0.04 -0.03 2.00 7 8.13 25561.4 25561.4 13066.9 0.05 0.06 1.96 8 10.84 34064.9 34063.0 16693.5 0.01 0.01 2.04 9 13.55 42584.6 42588.9 20978.0 0.02 0.03 2.03 10 16.25 51099.9 51104.0 25822.8 0.03 0.04 1.98 -------- --------- --------- --------- --------- --------- --------- --------- Dynamic range explored: from 3440 to 102750 e- Average count rate measured: 3143 ADU/sec. CONV. FACTOR AND RON ==================== C.Fact = 2.01 +/- 0.02 e-/ADU RON = 4.02 +/- 0.04 e- RMS SHUTTER ERROR ============= Average shutter error derived from fractional count rate = -0.001 sec LINEARITY ERROR =============== Average linearity error after shutter correct. = + 0.09/-0.18 % These errors represent maximum deviation in % from the average count rate after correction for shutter delay