*** MIDAS logfile (05SEPpl1.2) *** Su, 01 Oct 2006 15:15:59 Page 1 *** MIDAS logfile (vers. 05SEPpl1.2) *** Su, 01 Oct 2006 15:16:13 Page 2 ========================================================== SUMMARY STANDARD TEST CCD#46 TAKEN ON 061001 IN fastcd MODE ========================================================== BIAS ==== 5 biases at start test: average = 284.35 stddev = 2.16 FIERA temperature = 273.15 K There were 0 hot pixels/columns detected TRANSFER FUNCTION AND LINEARITY DATA ==================================== Table : Std_fastcd_46_061001 Sequence Exp_tim1 Med_cnt1 Med_cnt2 Variance Frc_cnt1 Frc_cnt2 el_adu1 -------- --------- --------- --------- --------- --------- --------- --------- 1 0.55 1706.5 1706.6 857.7 0.09 0.10 1.99 2 1.09 3395.7 3394.4 1700.5 -0.16 -0.18 2.00 3 2.17 6805.3 6806.4 3424.4 0.09 0.10 1.99 4 3.25 10188.0 10187.6 5082.6 -0.08 -0.08 2.00 5 4.88 15300.9 15298.4 7512.7 0.06 0.04 2.04 6 6.50 20382.8 20377.9 10073.9 -0.04 -0.05 2.02 7 8.13 25498.5 25501.2 12326.0 0.05 0.06 2.07 8 10.84 33972.1 33972.7 17302.2 -0.02 -0.01 1.96 9 13.55 42482.1 42481.5 21338.5 0.02 0.02 1.99 10 16.25 50963.6 50962.5 25965.2 -0.00 -0.00 1.96 -------- --------- --------- --------- --------- --------- --------- --------- Dynamic range explored: from 3363 to 100425 e- Average count rate measured: 3136 ADU/sec. CONV. FACTOR AND RON ==================== C.Fact = 1.97 +/- 0.02 e-/ADU RON = 4.25 +/- 0.04 e- RMS SHUTTER ERROR ============= Average shutter error derived from fractional count rate = -0.002 sec LINEARITY ERROR =============== Average linearity error after shutter correct. = + 0.10/-0.17 % These errors represent maximum deviation in % from the average count rate after correction for shutter delay