*** MIDAS logfile (05SEPpl1.2) *** Su, 07 Jan 2007 15:47:37 Page 1 *** MIDAS logfile (vers. 05SEPpl1.2) *** Su, 07 Jan 2007 15:47:52 Page 2 ========================================================== SUMMARY STANDARD TEST CCD#45 TAKEN ON 070107 IN normcd MODE ========================================================== BIAS ==== 5 biases at start test: average = 355.92 stddev = 1.97 FIERA temperature = 273.15 K There were 2 hot pixels/columns detected TRANSFER FUNCTION AND LINEARITY DATA ==================================== Table : Std_normcd_45_070107 Sequence Exp_tim1 Med_cnt1 Med_cnt2 Variance Frc_cnt1 Frc_cnt2 el_adu1 -------- --------- --------- --------- --------- --------- --------- --------- 1 2.17 1725.9 1726.0 819.4 0.15 0.15 2.11 2 4.34 3440.2 3439.6 1637.8 -0.20 -0.20 2.10 3 8.67 6885.2 6885.2 3253.4 -0.11 -0.11 2.12 4 13.00 10328.9 10327.9 5011.3 -0.11 -0.12 2.06 5 19.51 15498.6 15499.8 7484.7 -0.08 -0.08 2.07 6 26.01 20675.4 20676.9 10013.2 -0.03 -0.02 2.06 7 32.51 25854.3 25855.8 12537.6 0.01 0.01 2.06 8 43.34 34505.4 34505.0 16431.6 0.10 0.10 2.10 9 54.17 43138.3 43140.1 20325.8 0.12 0.12 2.12 10 65.01 51785.1 51787.5 24211.0 0.16 0.16 2.14 -------- --------- --------- --------- --------- --------- --------- --------- Dynamic range explored: from 3679 to 110376 e- Average count rate measured: 795 ADU/sec. CONV. FACTOR AND RON ==================== C.Fact = 2.13 +/- 0.01 e-/ADU RON = 4.19 +/- 0.03 e- RMS SHUTTER ERROR ============= Average shutter error derived from fractional count rate = -0.004 sec LINEARITY ERROR =============== Average linearity error after shutter correct. = + 0.16/-0.20 % These errors represent maximum deviation in % from the average count rate after correction for shutter delay