*** MIDAS logfile (03SEPpl1.2) *** Su, 22 May 2005 17:38:24 Page 1 *** MIDAS logfile (vers. 03SEPpl1.2) *** Su, 22 May 2005 17:38:40 Page 2 ========================================================== SUMMARY STANDARD TEST CCD#45 TAKEN ON 050522 IN normcd MODE ========================================================== BIAS ==== 5 biases at start test: average = 358.38 stddev = 2.02 FIERA temperature = 273.15 K There were 2 hot pixels/columns detected TRANSFER FUNCTION AND LINEARITY DATA ==================================== Table : Std_normcd_45_050522 Sequence Exp_tim1 Med_cnt1 Med_cnt2 Variance Frc_cnt1 Frc_cnt2 el_adu1 -------- --------- --------- --------- --------- --------- --------- --------- 1 3.08 1751.7 1751.7 836.1 0.12 0.14 2.09 2 6.16 3494.2 3494.2 1687.2 -0.19 -0.17 2.07 3 12.31 6995.2 6994.8 3351.3 -0.11 -0.11 2.09 4 18.47 10491.2 10490.8 5092.7 -0.13 -0.13 2.06 5 27.70 15744.5 15745.1 7592.8 -0.08 -0.08 2.07 6 36.93 21003.8 21003.5 10250.5 -0.03 -0.04 2.05 7 46.16 26269.8 26270.8 12739.6 0.02 0.02 2.06 8 61.54 35048.9 35048.6 16785.5 0.09 0.08 2.09 9 76.93 43838.1 43837.1 20914.5 0.15 0.14 2.10 10 92.31 52603.7 52604.6 24495.8 0.14 0.14 2.15 -------- --------- --------- --------- --------- --------- --------- --------- Dynamic range explored: from 3726 to 111879 e- Average count rate measured: 569 ADU/sec. CONV. FACTOR AND RON ==================== C.Fact = 2.13 +/- 0.02 e-/ADU RON = 4.29 +/- 0.04 e- RMS SHUTTER ERROR ============= Average shutter error derived from fractional count rate = -0.007 sec LINEARITY ERROR =============== Average linearity error after shutter correct. = + 0.15/-0.18 % These errors represent maximum deviation in % from the average count rate after correction for shutter delay