*** MIDAS logfile (05SEPpl1.2) *** Sa, 01 Mar 2008 14:32:55 Page 1 *** MIDAS logfile (vers. 05SEPpl1.2) *** Sa, 01 Mar 2008 14:33:09 Page 2 ========================================================== SUMMARY STANDARD TEST CCD#45 TAKEN ON 080301 IN fastcd MODE ========================================================== BIAS ==== 5 biases at start test: average = 298.25 stddev = 1.86 FIERA temperature = 273.15 K There were 0 hot pixels/columns detected TRANSFER FUNCTION AND LINEARITY DATA ==================================== Table : Std_fastcd_45_080301 Sequence Exp_tim1 Med_cnt1 Med_cnt2 Variance Frc_cnt1 Frc_cnt2 el_adu1 -------- --------- --------- --------- --------- --------- --------- --------- 1 0.55 1606.1 1604.4 756.8 0.08 0.05 2.12 2 1.09 3199.4 3198.6 1505.2 -0.17 -0.19 2.13 3 2.17 6414.4 6414.9 3096.5 0.06 0.07 2.07 4 3.25 9605.2 9604.6 4682.7 -0.10 -0.10 2.05 5 4.88 14423.3 14420.8 7057.1 0.01 0.01 2.04 6 6.50 19214.6 19219.6 9604.6 -0.08 -0.06 2.00 7 8.13 24044.6 24041.8 11994.7 0.02 0.02 2.00 8 10.84 32047.9 32053.3 16158.2 0.00 0.02 1.98 9 13.55 40080.0 40086.3 20135.1 0.05 0.06 1.99 10 16.25 48131.8 48130.2 23591.3 0.12 0.12 2.04 -------- --------- --------- --------- --------- --------- --------- --------- Dynamic range explored: from 3222 to 96600 e- Average count rate measured: 2958 ADU/sec. CONV. FACTOR AND RON ==================== C.Fact = 2.01 +/- 0.01 e-/ADU RON = 3.73 +/- 0.03 e- RMS SHUTTER ERROR ============= Average shutter error derived from fractional count rate = -0.003 sec LINEARITY ERROR =============== Average linearity error after shutter correct. = + 0.12/-0.18 % These errors represent maximum deviation in % from the average count rate after correction for shutter delay