*** MIDAS logfile (05SEPpl1.2) *** Su, 09 Dec 2007 14:08:17 Page 1 *** MIDAS logfile (vers. 05SEPpl1.2) *** Su, 09 Dec 2007 14:08:31 Page 2 ========================================================== SUMMARY STANDARD TEST CCD#45 TAKEN ON 071209 IN fastcd MODE ========================================================== BIAS ==== 5 biases at start test: average = 299.28 stddev = 1.86 FIERA temperature = 273.15 K There were 0 hot pixels/columns detected TRANSFER FUNCTION AND LINEARITY DATA ==================================== Table : Std_fastcd_45_071209 Sequence Exp_tim1 Med_cnt1 Med_cnt2 Variance Frc_cnt1 Frc_cnt2 el_adu1 -------- --------- --------- --------- --------- --------- --------- --------- 1 0.55 1606.0 1608.7 779.7 0.04 0.13 2.06 2 1.09 3202.5 3201.4 1577.2 -0.20 -0.24 2.03 3 2.17 6420.5 6422.6 3098.6 0.04 0.04 2.07 4 3.25 9615.7 9616.3 4583.6 -0.10 -0.11 2.10 5 4.88 14439.0 14440.9 7209.9 0.01 0.01 2.00 6 6.50 19241.6 19241.5 9276.5 -0.06 -0.07 2.07 7 8.13 24073.3 24074.3 12149.0 0.03 0.03 1.98 8 10.84 32094.0 32091.3 16522.1 0.03 0.01 1.94 9 13.55 40136.0 40136.3 19468.1 0.07 0.06 2.06 10 16.25 48192.1 48193.2 23875.2 0.14 0.13 2.02 -------- --------- --------- --------- --------- --------- --------- --------- Dynamic range explored: from 3235 to 96990 e- Average count rate measured: 2961 ADU/sec. CONV. FACTOR AND RON ==================== C.Fact = 2.01 +/- 0.03 e-/ADU RON = 3.75 +/- 0.05 e- RMS SHUTTER ERROR ============= Average shutter error derived from fractional count rate = -0.003 sec LINEARITY ERROR =============== Average linearity error after shutter correct. = + 0.13/-0.22 % These errors represent maximum deviation in % from the average count rate after correction for shutter delay