*** MIDAS logfile (05SEPpl1.2) *** We, 10 Oct 2007 16:35:36 Page 1 *** MIDAS logfile (vers. 05SEPpl1.2) *** We, 10 Oct 2007 16:35:50 Page 2 ========================================================== SUMMARY STANDARD TEST CCD#45 TAKEN ON 071010 IN fastcd MODE ========================================================== BIAS ==== 5 biases at start test: average = 299.48 stddev = 1.85 FIERA temperature = 273.15 K There were 0 hot pixels/columns detected TRANSFER FUNCTION AND LINEARITY DATA ==================================== Table : Std_fastcd_45_071010 Sequence Exp_tim1 Med_cnt1 Med_cnt2 Variance Frc_cnt1 Frc_cnt2 el_adu1 -------- --------- --------- --------- --------- --------- --------- --------- 1 0.55 1599.7 1600.3 761.3 0.07 0.09 2.10 2 1.09 3192.3 3192.2 1506.7 -0.17 -0.17 2.12 3 2.17 6401.7 6404.0 3125.6 0.05 0.06 2.05 4 3.25 9587.8 9586.4 4633.2 -0.10 -0.11 2.07 5 4.88 14399.1 14399.8 7085.6 0.01 0.02 2.03 6 6.50 19187.3 19184.8 9836.2 -0.07 -0.09 1.95 7 8.13 24004.7 24007.2 12184.1 0.02 0.03 1.97 8 10.84 32001.6 32001.9 15971.0 0.01 0.01 2.00 9 13.55 40024.1 40024.9 19981.5 0.06 0.05 2.00 10 16.25 48054.4 48057.7 24030.0 0.12 0.12 2.00 -------- --------- --------- --------- --------- --------- --------- --------- Dynamic range explored: from 3186 to 95683 e- Average count rate measured: 2954 ADU/sec. CONV. FACTOR AND RON ==================== C.Fact = 1.99 +/- 0.01 e-/ADU RON = 3.69 +/- 0.02 e- RMS SHUTTER ERROR ============= Average shutter error derived from fractional count rate = -0.004 sec LINEARITY ERROR =============== Average linearity error after shutter correct. = + 0.12/-0.17 % These errors represent maximum deviation in % from the average count rate after correction for shutter delay