*** MIDAS logfile (05SEPpl1.2) *** We, 03 Oct 2007 15:10:42 Page 1 *** MIDAS logfile (vers. 05SEPpl1.2) *** We, 03 Oct 2007 15:10:56 Page 2 ========================================================== SUMMARY STANDARD TEST CCD#45 TAKEN ON 071003 IN fastcd MODE ========================================================== BIAS ==== 5 biases at start test: average = 299.64 stddev = 1.92 FIERA temperature = 273.15 K There were 0 hot pixels/columns detected TRANSFER FUNCTION AND LINEARITY DATA ==================================== Table : Std_fastcd_45_071003 Sequence Exp_tim1 Med_cnt1 Med_cnt2 Variance Frc_cnt1 Frc_cnt2 el_adu1 -------- --------- --------- --------- --------- --------- --------- --------- 1 0.55 1593.1 1595.8 777.7 0.12 0.06 2.05 2 1.09 3175.6 3177.5 1553.2 -0.23 -0.24 2.04 3 2.17 6378.1 6373.1 3108.5 0.10 0.03 2.05 4 3.25 9546.4 9546.5 4608.2 -0.10 -0.09 2.07 5 4.88 14337.4 14336.3 7196.3 0.02 0.02 1.99 6 6.50 19099.9 19100.7 9479.1 -0.08 -0.06 2.01 7 8.13 23900.9 23905.2 11992.4 0.03 0.06 1.99 8 10.84 31855.6 31857.5 15724.2 -0.01 0.02 2.03 9 13.55 39854.7 39849.1 20604.3 0.07 0.09 1.93 10 16.25 47827.8 47830.3 23834.0 0.08 0.11 2.01 -------- --------- --------- --------- --------- --------- --------- --------- Dynamic range explored: from 3154 to 94605 e- Average count rate measured: 2940 ADU/sec. CONV. FACTOR AND RON ==================== C.Fact = 1.98 +/- 0.02 e-/ADU RON = 3.80 +/- 0.04 e- RMS SHUTTER ERROR ============= Average shutter error derived from fractional count rate = -0.004 sec LINEARITY ERROR =============== Average linearity error after shutter correct. = + 0.12/-0.24 % These errors represent maximum deviation in % from the average count rate after correction for shutter delay