*** MIDAS logfile (05SEPpl1.2) *** Th, 02 Aug 2007 15:37:07 Page 1 *** MIDAS logfile (vers. 05SEPpl1.2) *** Th, 02 Aug 2007 15:37:22 Page 2 ========================================================== SUMMARY STANDARD TEST CCD#45 TAKEN ON 070802 IN fastcd MODE ========================================================== BIAS ==== 5 biases at start test: average = 300.49 stddev = 1.90 FIERA temperature = 273.15 K There were 0 hot pixels/columns detected TRANSFER FUNCTION AND LINEARITY DATA ==================================== Table : Std_fastcd_45_070802 Sequence Exp_tim1 Med_cnt1 Med_cnt2 Variance Frc_cnt1 Frc_cnt2 el_adu1 -------- --------- --------- --------- --------- --------- --------- --------- 1 0.55 1625.5 1627.4 775.7 0.12 0.06 2.10 2 1.09 3241.7 3244.3 1588.9 -0.17 -0.20 2.04 3 2.17 6506.3 6504.2 3118.4 0.08 0.05 2.09 4 3.25 9739.8 9741.7 4739.7 -0.11 -0.09 2.05 5 4.88 14626.3 14627.0 7158.1 0.00 0.01 2.04 6 6.50 19487.6 19485.7 9623.4 -0.09 -0.08 2.03 7 8.13 24383.0 24385.8 12077.0 0.01 0.04 2.02 8 10.84 32506.5 32504.9 15714.3 -0.00 0.02 2.07 9 13.55 40652.7 40654.3 20583.7 0.05 0.07 1.97 10 16.25 48813.6 48814.9 24487.4 0.11 0.13 1.99 -------- --------- --------- --------- --------- --------- --------- --------- Dynamic range explored: from 3237 to 97151 e- Average count rate measured: 3000 ADU/sec. CONV. FACTOR AND RON ==================== C.Fact = 1.99 +/- 0.02 e-/ADU RON = 3.78 +/- 0.03 e- RMS SHUTTER ERROR ============= Average shutter error derived from fractional count rate = -0.004 sec LINEARITY ERROR =============== Average linearity error after shutter correct. = + 0.13/-0.18 % These errors represent maximum deviation in % from the average count rate after correction for shutter delay