*** MIDAS logfile (05SEPpl1.2) *** Su, 13 May 2007 16:21:22 Page 1 *** MIDAS logfile (vers. 05SEPpl1.2) *** Su, 13 May 2007 16:21:36 Page 2 ========================================================== SUMMARY STANDARD TEST CCD#45 TAKEN ON 070513 IN fastcd MODE ========================================================== BIAS ==== 5 biases at start test: average = 298.80 stddev = 1.85 FIERA temperature = 273.15 K There were 0 hot pixels/columns detected TRANSFER FUNCTION AND LINEARITY DATA ==================================== Table : Std_fastcd_45_070513 Sequence Exp_tim1 Med_cnt1 Med_cnt2 Variance Frc_cnt1 Frc_cnt2 el_adu1 -------- --------- --------- --------- --------- --------- --------- --------- 1 0.55 1673.3 1673.2 808.4 0.15 0.13 2.07 2 1.09 3329.9 3330.2 1601.7 -0.23 -0.23 2.08 3 2.17 6680.8 6681.7 3159.4 0.06 0.08 2.11 4 3.25 10001.5 9998.6 4775.0 -0.11 -0.12 2.09 5 4.88 15017.3 15019.9 7531.4 0.00 0.01 1.99 6 6.50 20010.4 20011.6 10305.2 -0.08 -0.07 1.94 7 8.13 25039.5 25039.2 12115.8 0.03 0.03 2.07 8 10.84 33376.2 33376.3 17581.8 0.01 0.01 1.90 9 13.55 41743.6 41748.1 20926.1 0.06 0.07 1.99 10 16.25 50108.7 50111.3 25306.0 0.10 0.10 1.98 -------- --------- --------- --------- --------- --------- --------- --------- Dynamic range explored: from 3282 to 98303 e- Average count rate measured: 3080 ADU/sec. CONV. FACTOR AND RON ==================== C.Fact = 1.96 +/- 0.03 e-/ADU RON = 3.64 +/- 0.05 e- RMS SHUTTER ERROR ============= Average shutter error derived from fractional count rate = -0.003 sec LINEARITY ERROR =============== Average linearity error after shutter correct. = + 0.14/-0.23 % These errors represent maximum deviation in % from the average count rate after correction for shutter delay