*** MIDAS logfile (05SEPpl1.2) *** Th, 08 Mar 2007 15:02:38 Page 1 *** MIDAS logfile (vers. 05SEPpl1.2) *** Th, 08 Mar 2007 15:02:52 Page 2 ========================================================== SUMMARY STANDARD TEST CCD#45 TAKEN ON 070308 IN fastcd MODE ========================================================== BIAS ==== 5 biases at start test: average = 297.90 stddev = 1.86 FIERA temperature = 273.15 K There were 0 hot pixels/columns detected TRANSFER FUNCTION AND LINEARITY DATA ==================================== Table : Std_fastcd_45_070308 Sequence Exp_tim1 Med_cnt1 Med_cnt2 Variance Frc_cnt1 Frc_cnt2 el_adu1 -------- --------- --------- --------- --------- --------- --------- --------- 1 0.55 1712.4 1712.5 833.1 0.03 0.03 2.06 2 1.09 3411.5 3411.3 1611.4 -0.20 -0.21 2.12 3 2.17 6841.2 6842.4 3353.1 0.05 0.05 2.04 4 3.25 10244.1 10246.2 4981.1 -0.10 -0.09 2.06 5 4.88 15385.5 15384.6 7419.6 0.02 0.01 2.07 6 6.50 20500.2 20501.3 10062.2 -0.06 -0.06 2.04 7 8.13 25647.8 25649.3 12469.0 0.04 0.04 2.06 8 10.84 34188.5 34190.3 17013.8 0.02 0.02 2.01 9 13.55 42764.3 42766.2 21374.0 0.08 0.08 2.00 10 16.25 51334.6 51338.0 25780.6 0.12 0.12 1.99 -------- --------- --------- --------- --------- --------- --------- --------- Dynamic range explored: from 3407 to 102131 e- Average count rate measured: 3155 ADU/sec. CONV. FACTOR AND RON ==================== C.Fact = 1.99 +/- 0.01 e-/ADU RON = 3.70 +/- 0.02 e- RMS SHUTTER ERROR ============= Average shutter error derived from fractional count rate = -0.003 sec LINEARITY ERROR =============== Average linearity error after shutter correct. = + 0.12/-0.21 % These errors represent maximum deviation in % from the average count rate after correction for shutter delay