*** MIDAS logfile (05SEPpl1.2) *** Su, 04 Feb 2007 15:26:01 Page 1 *** MIDAS logfile (vers. 05SEPpl1.2) *** Su, 04 Feb 2007 15:26:15 Page 2 ========================================================== SUMMARY STANDARD TEST CCD#45 TAKEN ON 070204 IN fastcd MODE ========================================================== BIAS ==== 5 biases at start test: average = 298.24 stddev = 1.87 FIERA temperature = 273.15 K There were 0 hot pixels/columns detected TRANSFER FUNCTION AND LINEARITY DATA ==================================== Table : Std_fastcd_45_070204 Sequence Exp_tim1 Med_cnt1 Med_cnt2 Variance Frc_cnt1 Frc_cnt2 el_adu1 -------- --------- --------- --------- --------- --------- --------- --------- 1 0.55 1703.3 1706.4 818.6 0.01 0.11 2.08 2 1.09 3401.0 3398.8 1559.9 -0.18 -0.22 2.18 3 2.17 6824.9 6822.7 3289.4 0.08 0.06 2.07 4 3.25 10218.7 10218.2 4876.4 -0.09 -0.10 2.10 5 4.88 15345.0 15344.7 7479.9 0.02 0.01 2.05 6 6.50 20446.3 20448.1 10007.5 -0.07 -0.07 2.04 7 8.13 25586.5 25586.3 13019.8 0.04 0.04 1.97 8 10.84 34102.3 34104.0 17421.9 0.01 0.01 1.96 9 13.55 42650.5 42651.0 21802.1 0.06 0.06 1.96 10 16.25 51207.7 51206.9 25253.7 0.11 0.11 2.03 -------- --------- --------- --------- --------- --------- --------- --------- Dynamic range explored: from 3373 to 101306 e- Average count rate measured: 3148 ADU/sec. CONV. FACTOR AND RON ==================== C.Fact = 1.98 +/- 0.02 e-/ADU RON = 3.69 +/- 0.04 e- RMS SHUTTER ERROR ============= Average shutter error derived from fractional count rate = -0.004 sec LINEARITY ERROR =============== Average linearity error after shutter correct. = + 0.11/-0.20 % These errors represent maximum deviation in % from the average count rate after correction for shutter delay