*** MIDAS logfile (05SEPpl1.2) *** Sa, 06 May 2006 14:57:13 Page 1 *** MIDAS logfile (vers. 05SEPpl1.2) *** Sa, 06 May 2006 14:57:27 Page 2 ========================================================== SUMMARY STANDARD TEST CCD#45 TAKEN ON 060506 IN fastcd MODE ========================================================== BIAS ==== 5 biases at start test: average = 294.98 stddev = 1.99 FIERA temperature = 273.15 K There were 0 hot pixels/columns detected TRANSFER FUNCTION AND LINEARITY DATA ==================================== Table : Std_fastcd_45_060506 Sequence Exp_tim1 Med_cnt1 Med_cnt2 Variance Frc_cnt1 Frc_cnt2 el_adu1 -------- --------- --------- --------- --------- --------- --------- --------- 1 0.77 1660.1 1660.3 795.0 0.05 0.06 2.09 2 1.54 3309.5 3309.3 1564.0 -0.08 -0.09 2.12 3 3.08 6615.8 6616.7 3158.5 -0.05 -0.05 2.09 4 4.62 9917.6 9921.5 4930.6 -0.07 -0.04 2.01 5 6.93 14867.0 14866.9 7267.9 -0.12 -0.12 2.05 6 9.23 19834.4 19833.1 9766.3 -0.05 -0.06 2.03 7 11.54 24809.7 24808.4 12596.4 0.03 0.02 1.97 8 15.39 33074.1 33075.8 16722.1 0.01 0.02 1.98 9 19.23 41398.5 41395.3 20988.9 0.16 0.15 1.97 10 23.08 49653.8 49652.5 24673.1 0.11 0.11 2.01 -------- --------- --------- --------- --------- --------- --------- --------- Dynamic range explored: from 3292 to 98472 e- Average count rate measured: 2149 ADU/sec. CONV. FACTOR AND RON ==================== C.Fact = 1.98 +/- 0.01 e-/ADU RON = 3.95 +/- 0.03 e- RMS SHUTTER ERROR ============= Average shutter error derived from fractional count rate = -0.000 sec LINEARITY ERROR =============== Average linearity error after shutter correct. = + 0.15/-0.12 % These errors represent maximum deviation in % from the average count rate after correction for shutter delay