*** MIDAS logfile (05SEPpl1.2) *** Mo, 01 May 2006 15:59:30 Page 1 *** MIDAS logfile (vers. 05SEPpl1.2) *** Mo, 01 May 2006 15:59:44 Page 2 ========================================================== SUMMARY STANDARD TEST CCD#45 TAKEN ON 060501 IN fastcd MODE ========================================================== BIAS ==== 5 biases at start test: average = 294.76 stddev = 2.03 FIERA temperature = 273.15 K There were 0 hot pixels/columns detected TRANSFER FUNCTION AND LINEARITY DATA ==================================== Table : Std_fastcd_45_060501 Sequence Exp_tim1 Med_cnt1 Med_cnt2 Variance Frc_cnt1 Frc_cnt2 el_adu1 -------- --------- --------- --------- --------- --------- --------- --------- 1 0.77 1654.4 1656.4 773.8 0.05 0.12 2.14 2 1.54 3299.2 3298.9 1588.1 -0.06 -0.06 2.08 3 3.08 6594.3 6591.9 3176.1 -0.03 -0.06 2.08 4 4.62 9884.4 9882.3 4814.9 -0.05 -0.07 2.05 5 6.93 14810.5 14812.8 7536.3 -0.14 -0.13 1.97 6 9.23 19761.2 19760.5 9842.5 -0.07 -0.07 2.01 7 11.54 24725.0 24718.2 12244.8 0.04 0.02 2.02 8 15.39 32956.5 32955.9 16427.6 0.01 0.01 2.01 9 19.23 41251.6 41244.4 20778.6 0.15 0.14 1.99 10 23.08 49481.4 49477.8 24626.7 0.11 0.11 2.01 -------- --------- --------- --------- --------- --------- --------- --------- Dynamic range explored: from 3302 to 98702 e- Average count rate measured: 2141 ADU/sec. CONV. FACTOR AND RON ==================== C.Fact = 1.99 +/- 0.01 e-/ADU RON = 4.04 +/- 0.02 e- RMS SHUTTER ERROR ============= Average shutter error derived from fractional count rate = -0.000 sec LINEARITY ERROR =============== Average linearity error after shutter correct. = + 0.14/-0.14 % These errors represent maximum deviation in % from the average count rate after correction for shutter delay