*** MIDAS logfile (03SEPpl1.2) *** Su, 02 Jan 2005 15:18:50 Page 1 *** MIDAS logfile (vers. 03SEPpl1.2) *** Su, 02 Jan 2005 15:19:06 Page 2 ========================================================== SUMMARY STANDARD TEST CCD#46 TAKEN ON 050102 IN fastcd MODE ========================================================== BIAS ==== 5 biases at start test: average = 297.91 stddev = 1.91 FIERA temperature = 273.15 K There were 0 hot pixels/columns detected TRANSFER FUNCTION AND LINEARITY DATA ==================================== Table : Std_fastcd_46_050102 Sequence Exp_tim1 Med_cnt1 Med_cnt2 Variance Frc_cnt1 Frc_cnt2 el_adu1 -------- --------- --------- --------- --------- --------- --------- --------- 1 0.77 1666.5 1665.7 777.3 0.02 0.07 2.14 2 1.54 3327.9 3328.6 1582.4 -0.06 -0.00 2.10 3 3.08 6652.3 6650.5 3242.1 -0.10 -0.12 2.05 4 4.62 9983.0 9984.7 4799.2 -0.03 -0.03 2.08 5 6.93 14958.1 14958.6 7376.5 -0.14 -0.15 2.03 6 9.23 19963.6 19961.5 9953.7 -0.05 -0.07 2.01 7 11.54 24966.2 24965.7 12561.2 0.01 -0.00 1.99 8 15.39 33303.7 33307.6 16419.0 0.06 0.05 2.03 9 19.23 41641.1 41646.1 21029.8 0.09 0.07 1.98 10 23.08 50021.1 50023.6 25255.3 0.19 0.18 1.98 -------- --------- --------- --------- --------- --------- --------- --------- Dynamic range explored: from 3292 to 98834 e- Average count rate measured: 2164 ADU/sec. CONV. FACTOR AND RON ==================== C.Fact = 1.98 +/- 0.01 e-/ADU RON = 3.77 +/- 0.02 e- RMS SHUTTER ERROR ============= Average shutter error derived from fractional count rate = -0.003 sec LINEARITY ERROR =============== Average linearity error after shutter correct. = + 0.18/-0.14 % These errors represent maximum deviation in % from the average count rate after correction for shutter delay