*** MIDAS logfile (03SEPpl1.2) *** Sa, 08 Oct 2005 13:56:37 Page 1 *** MIDAS logfile (vers. 03SEPpl1.2) *** Sa, 08 Oct 2005 13:57:36 Page 2 ========================================================== SUMMARY STANDARD TEST CCD#rC2 TAKEN ON 051008 IN normcd MODE ========================================================== BIAS ==== 5 biases at start test: average = 345.44 stddev = 4.01 FIERA temperature = 290.5 K There were 0 hot pixels/columns detected TRANSFER FUNCTION AND LINEARITY DATA ==================================== Table : Std_normcd_rC2_051008 Sequence Exp_tim1 Med_cnt1 Med_cnt2 Variance Frc_cnt1 Frc_cnt2 el_adu1 -------- --------- --------- --------- --------- --------- --------- --------- 1 1.00 968.0 967.5 813.5 0.09 0.05 1.19 2 2.00 1861.9 1861.7 1544.2 -0.06 -0.06 1.21 3 4.00 3652.5 3652.2 3001.3 -0.07 -0.06 1.22 4 6.00 5442.8 5443.1 4490.7 -0.07 -0.06 1.21 5 9.00 8131.5 8130.3 7577.3 -0.04 -0.04 1.07 6 12.00 10819.3 10818.4 8888.9 -0.02 -0.02 1.22 7 15.00 13509.7 13508.5 11196.4 0.00 0.00 1.21 8 20.00 17994.4 17995.7 14572.0 0.04 0.05 1.23 9 25.00 22481.9 22480.6 18158.7 0.06 0.06 1.24 10 30.00 26964.8 26966.7 22155.0 0.07 0.08 1.22 -------- --------- --------- --------- --------- --------- --------- --------- Dynamic range explored: from 1194 to 33267 e- Average count rate measured: 896 ADU/sec. CONV. FACTOR AND RON ==================== C.Fact = 1.23 +/- 0.02 e-/ADU RON = 4.95 +/- 0.07 e- RMS SHUTTER ERROR ============= Average shutter error derived from fractional count rate = 0.083 sec LINEARITY ERROR =============== Average linearity error after shutter correct. = + 0.09/-0.07 % These errors represent maximum deviation in % from the average count rate after correction for shutter delay