*** MIDAS logfile (05SEPpl1.2) *** Su, 14 Oct 2007 16:12:02 Page 1 *** MIDAS logfile (vers. 05SEPpl1.2) *** Su, 14 Oct 2007 16:12:17 Page 2 ========================================================== SUMMARY STANDARD TEST CCD#rB2 TAKEN ON 071014 IN normcd MODE ========================================================== BIAS ==== 5 biases at start test: average = 349.24 stddev = 5.46 FIERA temperature = 285.9 K There were 0 hot pixels/columns detected TRANSFER FUNCTION AND LINEARITY DATA ==================================== Table : Std_normcd_rB2_071014 Sequence Exp_tim1 Med_cnt1 Med_cnt2 Variance Frc_cnt1 Frc_cnt2 el_adu1 -------- --------- --------- --------- --------- --------- --------- --------- 1 1.06 1947.4 1947.0 2483.6 -0.06 -0.04 0.78 2 2.12 3737.9 3736.7 3022.0 0.16 0.17 1.24 3 4.25 7283.0 7282.5 6272.1 -0.18 -0.16 1.16 4 6.38 10850.7 10849.2 8532.0 -0.09 -0.10 1.27 5 9.57 16199.0 16197.2 12688.5 -0.05 -0.05 1.28 6 12.76 21567.9 21568.2 17038.1 0.07 0.07 1.27 7 15.95 26922.6 26922.8 20922.9 0.09 0.09 1.29 8 21.27 35846.9 35845.4 27729.3 0.10 0.09 1.29 9 26.59 44744.3 44745.5 34196.7 0.05 0.05 1.31 10 31.91 53579.7 53578.0 40168.4 -0.09 -0.10 1.33 -------- --------- --------- --------- --------- --------- --------- --------- Dynamic range explored: from 2617 to 72001 e- Average count rate measured: 1675 ADU/sec. CONV. FACTOR AND RON ==================== C.Fact = 1.34 +/- 0.01 e-/ADU RON = 7.34 +/- 0.06 e- RMS SHUTTER ERROR ============= Average shutter error derived from fractional count rate = 0.103 sec LINEARITY ERROR =============== Average linearity error after shutter correct. = + 0.16/-0.17 % These errors represent maximum deviation in % from the average count rate after correction for shutter delay