*** MIDAS logfile (05SEPpl1.2) *** Su, 02 Mar 2008 16:46:17 Page 1 *** MIDAS logfile (vers. 05SEPpl1.2) *** Su, 02 Mar 2008 16:46:33 Page 2 ========================================================== SUMMARY STANDARD TEST CCD#rA2 TAKEN ON 080302 IN normcd MODE ========================================================== BIAS ==== 5 biases at start test: average = 301.22 stddev = 5.44 FIERA temperature = 288.2 K There were 0 hot pixels/columns detected TRANSFER FUNCTION AND LINEARITY DATA ==================================== Table : Std_normcd_rA2_080302 Sequence Exp_tim1 Med_cnt1 Med_cnt2 Variance Frc_cnt1 Frc_cnt2 el_adu1 -------- --------- --------- --------- --------- --------- --------- --------- 1 1.06 1653.8 1654.4 1341.4 -0.14 -0.14 1.23 2 2.12 3216.7 3218.4 2583.7 0.22 0.23 1.25 3 4.25 6316.2 6315.9 5092.1 -0.01 -0.01 1.24 4 6.38 9425.0 9426.0 7571.9 0.04 0.04 1.24 5 9.57 14086.3 14086.6 11118.4 0.04 0.04 1.27 6 12.76 18761.0 18760.7 14801.5 0.11 0.11 1.27 7 15.95 23419.2 23418.0 19592.8 0.08 0.08 1.20 8 21.27 31166.9 31171.6 24287.7 0.00 0.01 1.28 9 26.59 38898.8 38896.0 30305.5 -0.08 -0.10 1.28 10 31.91 46576.1 46578.2 35168.4 -0.26 -0.26 1.32 -------- --------- --------- --------- --------- --------- --------- --------- Dynamic range explored: from 2165 to 60966 e- Average count rate measured: 1460 ADU/sec. CONV. FACTOR AND RON ==================== C.Fact = 1.31 +/- 0.02 e-/ADU RON = 7.13 +/- 0.11 e- RMS SHUTTER ERROR ============= Average shutter error derived from fractional count rate = 0.075 sec LINEARITY ERROR =============== Average linearity error after shutter correct. = + 0.22/-0.26 % These errors represent maximum deviation in % from the average count rate after correction for shutter delay