*** MIDAS logfile (05SEPpl1.2) *** Su, 14 Oct 2007 15:45:08 Page 1 *** MIDAS logfile (vers. 05SEPpl1.2) *** Su, 14 Oct 2007 15:45:28 Page 2 ========================================================== SUMMARY STANDARD TEST CCD#rA1 TAKEN ON 071014 IN normcd MODE ========================================================== BIAS ==== 5 biases at start test: average = 258.46 stddev = 4.50 FIERA temperature = 285.3 K There were 0 hot pixels/columns detected TRANSFER FUNCTION AND LINEARITY DATA ==================================== Table : Std_normcd_rA1_071014 Sequence Exp_tim1 Med_cnt1 Med_cnt2 Variance Frc_cnt1 Frc_cnt2 el_adu1 -------- --------- --------- --------- --------- --------- --------- --------- 1 4.25 1708.0 1708.0 1378.0 -0.09 -0.10 1.24 2 8.51 3378.4 3378.7 2710.0 0.07 0.08 1.25 3 17.02 6715.6 6714.9 5343.5 0.11 0.11 1.26 4 25.53 10051.4 10051.4 7866.6 0.11 0.11 1.28 5 38.29 15057.8 15057.5 11594.6 0.13 0.13 1.30 6 51.06 20056.2 20055.4 15189.7 0.10 0.10 1.32 7 63.83 25052.8 25052.5 18712.4 0.07 0.07 1.34 8 85.10 33361.1 33361.4 24107.8 -0.01 -0.01 1.38 9 106.38 41631.1 41630.7 29195.4 -0.16 -0.15 1.43 10 127.66 49858.4 49858.3 34036.6 -0.34 -0.33 1.46 -------- --------- --------- --------- --------- --------- --------- --------- Dynamic range explored: from 2503 to 73056 e- Average count rate measured: 392 ADU/sec. CONV. FACTOR AND RON ==================== C.Fact = 1.47 +/- 0.03 e-/ADU RON = 6.59 +/- 0.11 e- RMS SHUTTER ERROR ============= Average shutter error derived from fractional count rate = 0.115 sec LINEARITY ERROR =============== Average linearity error after shutter correct. = + 0.13/-0.33 % These errors represent maximum deviation in % from the average count rate after correction for shutter delay