*** MIDAS logfile (03SEPpl1.2) *** Th, 27 Oct 2005 18:46:32 Page 1 *** MIDAS logfile (vers. 03SEPpl1.2) *** Th, 27 Oct 2005 18:47:49 Page 2 ========================================================== SUMMARY STANDARD TEST CCD#rD2 TAKEN ON 051027 IN fastcd MODE ========================================================== BIAS ==== 5 biases at start test: average = 378.64 stddev = 9.77 FIERA temperature = 291.0 K There were 0 hot pixels/columns detected TRANSFER FUNCTION AND LINEARITY DATA ==================================== Table : Std_fastcd_rD2_051027 Sequence Exp_tim1 Med_cnt1 Med_cnt2 Variance Frc_cnt1 Frc_cnt2 el_adu1 -------- --------- --------- --------- --------- --------- --------- --------- 1 1.00 774.5 775.0 664.9 0.01 0.03 1.16 2 2.00 1527.6 1528.1 1237.7 -0.06 -0.05 1.23 3 4.00 3036.4 3036.8 2338.4 -0.01 0.00 1.30 4 6.00 4544.2 4543.3 3471.8 -0.01 -0.03 1.31 5 9.00 6804.3 6804.0 5148.3 -0.03 -0.04 1.32 6 12.00 9067.7 9067.0 6789.3 -0.01 -0.01 1.34 7 15.00 11329.9 11331.3 8473.9 0.00 0.01 1.34 8 20.00 15101.9 15102.5 11235.0 0.02 0.02 1.34 9 25.00 18875.8 18876.7 14049.4 0.03 0.03 1.34 10 30.00 22646.9 22647.2 16511.6 0.04 0.03 1.37 -------- --------- --------- --------- --------- --------- --------- --------- Dynamic range explored: from 1061 to 31020 e- Average count rate measured: 754 ADU/sec. CONV. FACTOR AND RON ==================== C.Fact = 1.37 +/- 0.01 e-/ADU RON = 13.39 +/- 0.07 e- RMS SHUTTER ERROR ============= Average shutter error derived from fractional count rate = 0.030 sec LINEARITY ERROR =============== Average linearity error after shutter correct. = + 0.04/-0.05 % These errors represent maximum deviation in % from the average count rate after correction for shutter delay