*** MIDAS logfile (03SEPpl1.2) *** Th, 27 Oct 2005 18:45:08 Page 1 *** MIDAS logfile (vers. 03SEPpl1.2) *** Th, 27 Oct 2005 18:46:25 Page 2 ========================================================== SUMMARY STANDARD TEST CCD#rC2 TAKEN ON 051027 IN fastcd MODE ========================================================== BIAS ==== 5 biases at start test: average = 346.62 stddev = 9.67 FIERA temperature = 291.0 K There were 0 hot pixels/columns detected TRANSFER FUNCTION AND LINEARITY DATA ==================================== Table : Std_fastcd_rC2_051027 Sequence Exp_tim1 Med_cnt1 Med_cnt2 Variance Frc_cnt1 Frc_cnt2 el_adu1 -------- --------- --------- --------- --------- --------- --------- --------- 1 1.00 896.8 897.2 768.5 0.09 0.03 1.17 2 2.00 1725.4 1725.8 1454.3 -0.06 -0.08 1.19 3 4.00 3385.3 3385.4 2669.2 -0.06 -0.06 1.27 4 6.00 5045.1 5044.4 4076.9 -0.06 -0.06 1.24 5 9.00 7534.2 7533.5 5805.8 -0.05 -0.06 1.30 6 12.00 10028.6 10028.3 7697.4 -0.01 0.01 1.30 7 15.00 12520.3 12521.8 9509.2 0.01 0.03 1.32 8 20.00 16677.6 16677.8 12676.9 0.04 0.06 1.32 9 25.00 20832.0 20833.6 15689.4 0.05 0.07 1.33 10 30.00 24985.7 24985.7 18568.5 0.05 0.06 1.35 -------- --------- --------- --------- --------- --------- --------- --------- Dynamic range explored: from 1211 to 33734 e- Average count rate measured: 830 ADU/sec. CONV. FACTOR AND RON ==================== C.Fact = 1.35 +/- 0.01 e-/ADU RON = 13.05 +/- 0.07 e- RMS SHUTTER ERROR ============= Average shutter error derived from fractional count rate = 0.082 sec LINEARITY ERROR =============== Average linearity error after shutter correct. = + 0.08/-0.07 % These errors represent maximum deviation in % from the average count rate after correction for shutter delay