*** MIDAS logfile (03SEPpl1.2) *** Th, 20 Oct 2005 16:56:19 Page 1 *** MIDAS logfile (vers. 03SEPpl1.2) *** Th, 20 Oct 2005 16:57:19 Page 2 ========================================================== SUMMARY STANDARD TEST CCD#rC2 TAKEN ON 051020 IN fastcd MODE ========================================================== BIAS ==== 5 biases at start test: average = 346.99 stddev = 9.33 FIERA temperature = 291.5 K There were 0 hot pixels/columns detected TRANSFER FUNCTION AND LINEARITY DATA ==================================== Table : Std_fastcd_rC2_051020 Sequence Exp_tim1 Med_cnt1 Med_cnt2 Variance Frc_cnt1 Frc_cnt2 el_adu1 -------- --------- --------- --------- --------- --------- --------- --------- 1 1.00 897.3 897.6 768.1 0.06 0.06 1.17 2 2.00 1729.0 1728.2 1444.0 -0.08 -0.10 1.20 3 4.00 3393.3 3393.9 2683.6 -0.06 -0.05 1.26 4 6.00 5057.8 5057.5 3945.2 -0.07 -0.06 1.28 5 9.00 7555.7 7555.6 5806.0 -0.05 -0.05 1.30 6 12.00 10057.3 10057.5 7685.1 -0.00 -0.00 1.31 7 15.00 12559.1 12558.9 9542.8 0.03 0.03 1.32 8 20.00 16727.9 16728.2 13036.4 0.05 0.05 1.28 9 25.00 20896.2 20896.8 15792.3 0.06 0.07 1.32 10 30.00 25063.2 25062.5 18836.5 0.06 0.06 1.33 -------- --------- --------- --------- --------- --------- --------- --------- Dynamic range explored: from 1195 to 33359 e- Average count rate measured: 833 ADU/sec. CONV. FACTOR AND RON ==================== C.Fact = 1.33 +/- 0.01 e-/ADU RON = 12.42 +/- 0.08 e- RMS SHUTTER ERROR ============= Average shutter error derived from fractional count rate = 0.080 sec LINEARITY ERROR =============== Average linearity error after shutter correct. = + 0.06/-0.09 % These errors represent maximum deviation in % from the average count rate after correction for shutter delay