*** MIDAS logfile (03SEPpl1.2) *** Th, 23 Jun 2005 18:00:51 Page 1 *** MIDAS logfile (vers. 03SEPpl1.2) *** Th, 23 Jun 2005 18:01:57 Page 2 ========================================================== SUMMARY STANDARD TEST CCD#rC2 TAKEN ON 050623 IN fastcd MODE ========================================================== BIAS ==== 5 biases at start test: average = 340.79 stddev = 14.91 FIERA temperature = 291.0 K There were 0 hot pixels/columns detected TRANSFER FUNCTION AND LINEARITY DATA ==================================== Table : Std_fastcd_rC2_050623 Sequence Exp_tim1 Med_cnt1 Med_cnt2 Variance Frc_cnt1 Frc_cnt2 el_adu1 -------- --------- --------- --------- --------- --------- --------- --------- 1 1.00 923.6 923.5 928.9 0.05 0.04 0.99 2 2.00 1770.3 1770.1 1564.3 -0.10 -0.11 1.13 3 4.00 3466.2 3466.5 2861.5 -0.07 -0.07 1.21 4 6.00 5162.9 5163.4 4143.5 -0.05 -0.04 1.25 5 9.00 7708.0 7707.1 6066.1 -0.03 -0.04 1.27 6 12.00 10254.8 10255.3 7973.8 0.00 0.01 1.29 7 15.00 12803.4 12803.1 9875.8 0.03 0.03 1.30 8 20.00 17048.8 17049.2 13091.6 0.05 0.05 1.30 9 25.00 21294.9 21295.5 17103.4 0.06 0.07 1.25 10 30.00 25536.1 25537.2 19096.4 0.05 0.06 1.34 -------- --------- --------- --------- --------- --------- --------- --------- Dynamic range explored: from 1218 to 33686 e- Average count rate measured: 848 ADU/sec. CONV. FACTOR AND RON ==================== C.Fact = 1.32 +/- 0.02 e-/ADU RON = 19.67 +/- 0.32 e- RMS SHUTTER ERROR ============= Average shutter error derived from fractional count rate = 0.091 sec LINEARITY ERROR =============== Average linearity error after shutter correct. = + 0.07/-0.11 % These errors represent maximum deviation in % from the average count rate after correction for shutter delay